There are 3 safety recalls on file for the 1994 AM General Hummer,
filed between September 1994 and March 1996.
Each one is repaired free by a franchised AM General dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1994 Hummer is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1996 (1)
The coating used to protect the accelerator pedal shaft is incompatible with the bronze bushing through which the shaft passes. Over time, and in the presence of a corrosive environment (water, road salt), the shaft CAN corrode inside the bushing increasing the amount of friction between the rotating shaft and the stationary bushing.
Risk and remedy
- Risk
- A corroded accelerator pedal shaft CAN cause the engine throttle to bind and not fully return to idle when the operator's foot is removed from the accelerator pedal increasing the potential for a vehicle accident.
- Remedy
- Dealers will install a revised accelerator pedal and shaft assembly.
- Filed by
- AM GENERAL CORPORATION
1995 (1)
Water CAN accumulate in the cruise control cable and if the outside temperature is below freezing and the cruise control is engaged, the water CAN freeze causing the cable to bind and not release as intended when the brake pedal is applied or the system is turned off AT the master cruise control switch.
Risk and remedy
- Risk
- The engine throttle CAN stick open resulting in loss of throttle control with the increased potential for a vehicle accident.
- Remedy
- Dealers will remove the current cruise control actuator and cable assembly and install a new assembly. Additionally, dealers will change the routing of the cable.
- Filed by
- AM GENERAL CORPORATION
1994 (1)
The oil pressure switch which controls the power to the electric fuel pump CAN fail. Failure is due to a missing rubber seal between the switch and the wiring harness. The missing seal allows contaminants to enter the switch causing it to fail in the open or closed position.
Risk and remedy
- Risk
- If the switch fails in the closed position, the pump will continue to run when the engine is off, draining the battery. If the switch fails in the open position it will cause poor performance and possibly stalling.
- Remedy
- Dealers will inspect the vehicles for the presence of the seal. If the seal is missing, the switch will be replaced and a new seal will be installed.
- Filed by
- AM GENERAL CORPORATION
Recall questions
How many recalls does the 1994 AM General Hummer have?
NHTSA lists 3 recalls for the 1994 AM General Hummer.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.