Owners of the 1992 BMW 325i have reported 14 engine problems to NHTSA, 35% of all complaints about this model year.
Where owners named a specific part, the most common were cooling system (12) and engine (3).
Complaints were filed between March 1997 and October 2002.
For comparison, the 2006 325i has the most engine complaints of any year, with 77.
Engine and cooling: stalling, loss of power, oil consumption, overheating, knocking, failed internal parts and check-engine faults traced to the engine.
1 recall for this model year involves the engine.
If your problem matches, a dealer repairs it free under the recall.
Complaints14
Typical mileagen/a
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Cooling System12
Engine3
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
EngineFiled Oct 2002CA
Took car through car wash. Car came out dead. Turns out that this is a common problem where water gets into the main ECM computer and shorts it out. This is terrible. BMW should issue a recall for this. $1100 for going through a simple car wash. Owners should be cautioned. Mr
Owner complaint 768077 filed with NHTSA
EngineFiled Aug 2002TX
The water pump locked up, the fan blade broke and the belts burned, dealer replaced the water pump, fan and belts, the oil pan gasket was replaced due to an oil leak.
Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, CAN result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
Risk and remedy
Risk
If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
Remedy
Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.