Owners of the 1999 BMW 328i have reported 8 brakes problems to NHTSA, 8% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (3), pedals and linkages (2), and antilock/traction control/electronic limited slip (2).
The typical report came at around 30,000 miles, and complaints were filed between January 2000 and April 2011.
These brakes complaints include 2 crashes.
For comparison, the 2013 328i has the most brakes complaints of any year, with 31.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Apr 2011105,000 milesCA
Tl* the contact owns a 1999 BMW 328i. While driving approximately 60 MPH, the contact engaged the brakes but noticed that the brakes would not engage until excessive force was applied to the brakes. The failure recurred whenever the brakes were applied. The vehicle was taken to an authorized dealer where the contact was told that the brake booster clip was defective. The vehicle was repaired. The manufacturer was notified of the failure and the contact was told that the vehicle was not included in the recall associated with NHTSA campaign ID number: 99v100000 (service brakes, hydraulic:pedals and linkages).
Owner complaint 10398047 filed with NHTSA
BrakesFiled Jun 2004NJ
While braking steering wheel vibrates hard which may result in a loss of vehicle control. Dealer states:rubber lower control arm bushings need to be replaced with updated poly urethane ones. Cost:$448.00.
Vehicle description: passenger vehicles. It is possible that the retaining clip that secures the brake booster pushrod to the brake pedal arm was not properly installed during production. It is possible for the clip to detach from the pin on the brake pedal arm allowing the pushrod to disconnect from the arm.
Risk and remedy
Risk
If this occurs, braking is not possible.
Remedy
Dealers will inspect the clip for tight installation and replace the clip if it is loose.