Owners of the 1990 BMW 525i have reported 6 engine problems to NHTSA, 55% of all complaints about this model year.
Where owners named a specific part, the most common were cooling system (9), engine (3), and exhaust system (2).
The typical report came at around 140,000 miles, and complaints were filed between March 1997 and August 2006.
For comparison, the 2007 525i has the most engine complaints of any year, with 9.
Engine and cooling: stalling, loss of power, oil consumption, overheating, knocking, failed internal parts and check-engine faults traced to the engine.
1 recall for this model year involves the engine.
If your problem matches, a dealer repairs it free under the recall.
Complaints6
Typical mileage140k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Cooling System9
Engine3
Exhaust System2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
EngineFiled Aug 2006140,201 milesNJ
(1) my 1990 BMW 525i started to over heat on August 01,2006. The temp gauge goes up 50% mark. The coolant level went down every day and I filled it up with distilled water to control the temperature, hoping that it would correct itself some time. (2) I could not drive the car on regular basis anymore. Within few days, I saw coolant overflowing and spray-out. Following this, I noticed slight rough idle and vibration. (3) realizing that driving the car was no more safe, I called westchester BMW, white plains, ny. On emergency basis, the dealer accepted the car the following week for diagnosis.
Owner complaint 10165963 filed with NHTSA
EngineFiled May 2002CA
While driving, coolant level warning light illuminated and consumer noticed white smoke coming from the rear of the vehicle, consumer found that water was in the oil due to a cracked head, consumer later received recall 98v178.
Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, CAN result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
Risk and remedy
Risk
If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
Remedy
Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.