There are 4 safety recalls on file for the 1991 BMW 525i,
filed between July 1996 and August 1998.
Each one is repaired free by a franchised BMW dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1991 525i is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1998 (1)
Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, CAN result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
Risk and remedy
- Risk
- If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
- Remedy
- Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
- Filed by
- BAYERISCHE MOTOREN WERKE
1997 (1)
97V131000
Filed Aug 19, 1997 410,000 vehicles
The cruise control and throttle cables are attached to the same throttle valve actuating lever AT the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing CAN separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.
Risk and remedy
- Risk
- This could cause the throttle valve to remain partially open. It his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
- Remedy
- Dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
- Filed by
- BAYERISCHE MOTOREN WERKE
1996 (2)
The brake light switch CAN fail allowing the switch to remain in the "brake lights off" position or in the "brake lights on" position.
Risk and remedy
- Risk
- If this happens, the brake lights either will not operate or will be continuously on, regardless of brake pedal position. Following drivers would not be able to determine whether the vehicle is stopping, increasing the potential for a vehicle accident.
- Remedy
- Dealers will replace the existing brake light switch with a newly designed switch.
- Filed by
- BAYERISCHE MOTOREN WERKE
The air bag contact ring locking tab located in the steering wheel assembly CAN break without warning.
Risk and remedy
- Risk
- If this happens, the contact ring wiring could eventually break. The air bag readiness indicator lamp (SRS or airbag) in the instrument cluster will illuminate, and the air bag would not deploy in the event of a frontal impact vehicle collision.
- Remedy
- Dealers will replace the locking tab with one of a different design.
- Filed by
- BAYERISCHE MOTOREN WERKE
Recall questions
How many recalls does the 1991 BMW 525i have?
NHTSA lists 4 recalls for the 1991 BMW 525i.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.