BMW · 540i

1994 BMW 540i Recalls

Compact car · RWD · Premium

There are 4 safety recalls on file for the 1994 BMW 540i, filed between January 1994 and August 1998. Each one is repaired free by a franchised BMW dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1994 540i is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1998 (1)

98V178000 Filed Aug 4, 1998 340,000 vehicles

Cooling system

Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, CAN result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.

Risk and remedy
Risk
If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
Remedy
Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
Filed by
BAYERISCHE MOTOREN WERKE

1997 (1)

97V131000 Filed Aug 19, 1997 410,000 vehicles

Vehicle speed control

The cruise control and throttle cables are attached to the same throttle valve actuating lever AT the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing CAN separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.

Risk and remedy
Risk
This could cause the throttle valve to remain partially open. It his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
Remedy
Dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
Filed by
BAYERISCHE MOTOREN WERKE

1996 (1)

96V111000 Filed Jul 1, 1996 180,000 vehicles

Switch

The brake light switch CAN fail allowing the switch to remain in the "brake lights off" position or in the "brake lights on" position.

Risk and remedy
Risk
If this happens, the brake lights either will not operate or will be continuously on, regardless of brake pedal position. Following drivers would not be able to determine whether the vehicle is stopping, increasing the potential for a vehicle accident.
Remedy
Dealers will replace the existing brake light switch with a newly designed switch.
Filed by
BAYERISCHE MOTOREN WERKE

1994 (1)

94V017000 Filed Jan 27, 1994 1,400 vehicles

Power window devices and controls

The remote activation device CAN close windows and sunroof from a distance greater than the maximum (6 meters) permitted by fmvss no.118, "power operated window systems."

Risk and remedy
Risk
Consequence of non-compliance: this could allow windows or sunroofs to be closed on an arm or neck of an individual when the remote device operator is not within the immediate vicinity.
Remedy
Replace the inside rear view mirror which has the activation receiver with one whose receiver will control the door locking and theft alarm, but will not permit remote operation of the windows and sunroof.
Filed by
BAYERISCHE MOTOREN WERKE

Recall questions

How many recalls does the 1994 BMW 540i have?

NHTSA lists 4 recalls for the 1994 BMW 540i.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.