BMW · M3

1995 BMW M3 Recalls

Subcompact car · RWD · Premium

There are 4 safety recalls on file for the 1995 BMW M3, filed between August 1994 and August 1998. Each one is repaired free by a franchised BMW dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1995 M3 is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1998 (1)

98V178000 Filed Aug 4, 1998 340,000 vehicles

Cooling system

Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, CAN result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.

Risk and remedy
Risk
If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
Remedy
Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
Filed by
BAYERISCHE MOTOREN WERKE

1997 (1)

97V131000 Filed Aug 19, 1997 410,000 vehicles

Vehicle speed control

The cruise control and throttle cables are attached to the same throttle valve actuating lever AT the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing CAN separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.

Risk and remedy
Risk
This could cause the throttle valve to remain partially open. It his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
Remedy
Dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
Filed by
BAYERISCHE MOTOREN WERKE

1996 (1)

96V111000 Filed Jul 1, 1996 180,000 vehicles

Switch

The brake light switch CAN fail allowing the switch to remain in the "brake lights off" position or in the "brake lights on" position.

Risk and remedy
Risk
If this happens, the brake lights either will not operate or will be continuously on, regardless of brake pedal position. Following drivers would not be able to determine whether the vehicle is stopping, increasing the potential for a vehicle accident.
Remedy
Dealers will replace the existing brake light switch with a newly designed switch.
Filed by
BAYERISCHE MOTOREN WERKE

1994 (1)

94V151000 Filed Aug 10, 1994 57,000 vehicles

Anchorage

In a fmvss no. 208 30 miles-per-hour compliance test, an unbelted test driver dummy's chest maximum resultant acceleration was 70.8 g's, which exceeds the maximum allowable value of 60 g's. Also, the unbelted passenger dummy's left femur maximum load was 2361 lbs, which exceeds maximum allowable value of 2250 lbs. The vehicles do not comply with fmvss no. 208, "occupant crash protection."

Risk and remedy
Risk
Consequence of non-compliance: in the event of an accident, the occupant will be subjected to an increased risk of injury.
Remedy
On automatic transmission models only, the dealer will replace the transmission support crossmember with a crossmember used on the manual transmission model. Also, the transmission rear bushing supports will be replaced with bushing having different performance characteristics. The steering column front support bearing AT the firewall will be replaced with a modified part using a teflon inner surface and teflon spray will be applied to the column housing in the area of the bearing. A brace will be added between the knee bolster support and the steering column.
Filed by
BAYERISCHE MOTOREN WERKE

Recall questions

How many recalls does the 1995 BMW M3 have?

NHTSA lists 4 recalls for the 1995 BMW M3.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.