Owners of the 2001 BMW X5 have reported 11 brakes problems to NHTSA, 7% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (3), foundation components (2), and supply (1).
The typical report came at around 130,000 miles, and complaints were filed between April 2001 and June 2016.
These brakes complaints include 1 fire.
For comparison, the 2024 X5 has the most brakes complaints of any year, with 90.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
3 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled May 2015181,060 milesFL
Tl* the contact owns a 2001 BMW X5. Without warning, the motor assembly fan failed and caused extensive radiator and engine damage. The radiator was extremely hot due to the failure. The vehicle was towed to an authorized dealer who diagnosed that the motor assembly fan needed to be replaced. The contact also mentioned that there was intermittent brake failure. The vehicle was taken to the dealer who made several unknown repairs, but the failure recurred. The brake pedal was not completely stopping the vehicle when it was depressed.
Owner complaint 10715611 filed with NHTSA
BrakesFiled Mar 2014157,000 milesMAFire
Tl* the contact owns a 2001 BMW X5. The contact stated that the brake light failed to shut off and the ABS warning lamp illuminated. The contact mentioned that after parking the vehicle, black smoke started to emit from the engine compartment. After inspecting the vehicle, he noticed that the master cylinder was completely melted. The vehicle was not taken to the dealer. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure and current mileage was 157,000.
On certain sport utility vehicles, it may be possible for the front brake line to slip out of the retaining bracket located AT the front strut. The brake hose that is attached to the brake line could come in contact with the tire and be subjected to wear and abrasion.
Risk and remedy
Risk
This could initially cause some brake fluid leakage, and eventually lead to a substantial loss of brake fluid. There could be a noticeable reduction in brake performance if a loss of front brake performance occurs.
Remedy
Dealers will install an additional retaining clip to further secure the brake line to the front strut. Additionally, if inspection of any brake hose indicates that it has experienced damage, the hose will be replaced. Owner notification began february 14, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact BMW AT 1-800-831-1117.
On certain passenger vehicles, due to a manufacturing problem, the brake pedal arm pivot shaft could loosen from its support bracket.
Risk and remedy
Risk
Eventually, the brake pedal arm could detach from the bracket, rendering the service braking system ineffective, increasing the risk of a crash.
Remedy
Dealers will check the brake pedal arm pivot shaft for proper seating in its support bracket. In addition, a pin will be installed to secure the shaft to the bracket. Owner notification began august 14, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact BMW AT 1-800-332-4269.
Vehicle description: sport utility vehicles. Due to an assembly error, one or both self-locking nuts that secure the pedal assembly to the booster may have been cross-threaded on the booster studs that protrude through the firewall. In such a case, the nut(s) would not be fully seated on the stud(s).
Risk and remedy
Risk
If this occurred, the effective brake pedal travel could be reduced due to relative movement between the pedal and booster. Braking performance while driving could be adversely affected. In addition, it is possible that the booster could develop a leak after an extended period of time resulting in a reduction in brake power assist.
Remedy
Dealers will inspect the two lock nuts to determine if they are properly seated. If the nuts are not properly seated or are cross-threaded, the brake booster will be replaced. Owner notification began august 17, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact BMW AT 1-800-831-1117.