There are 6 safety recalls on file for the 1991 Buick Regal,
filed between October 1991 and July 2000.
Each one is repaired free by a franchised Buick dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1991 Regal is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2000 (1)
00V189000
Filed Jul 11, 2000 713,435 vehicles
Vehicle description: passenger vehicles originally sold or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, where road salt use is heavy. A condition where one or both front engine cradle bolts CAN pull through the retainers due to corrosion of the retainers.
Risk and remedy
- Risk
- If both bolts pull through, the front of the cradle would no longer be supported AT the mounting locations and the steering intermediate shaft could separate from the steering gear.
- Remedy
- Dealers will replace the front and rear frame/cradle bolts and retainers.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 00061/00065)
1997 (1)
Vehicle description: passenger vehicles and mini vans originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont and wisconsin. The rear cradle bolts pull through the retainers due to corrosion of the retainer. If both bolts pull through, the rear cradle would not longer be supported AT these mounting locations and the steering intermediate shaft CAN separate from the steering gear.
Risk and remedy
- Risk
- If this were to occur while the vehicle was in motion, a vehicle crash could result.
- Remedy
- Dealers will replace the rear cradle bolts and retainers.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 97016)
1995 (1)
Incorrect clear front side marker bulbs were installed rather than amber bulbs. This does not conform to the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment."
Risk and remedy
- Risk
- Consequence of non-compliance: during illumination, the bulbs will show clear rather than amber and could momentarily confuse other drivers.
- Remedy
- Dealers will replace the clear bulbs with the correct amber bulbs.
- Filed by
- GENERAL MOTORS CORP.
1993 (1)
The fuel feed hose CAN pull out of the crimped coupling AT the engine end of the hose assembly, causing fuel leakage.
Risk and remedy
- Risk
- If the coupling were to separate and an ignition sourceis present, an engine compartment fire could occur.
- Remedy
- Install a new fuel feed hose.
- Filed by
- GENERAL MOTORS CORP.
1992 (1)
92V003000
Filed Jan 10, 1992 347,866 vehicles
The front door shoulder belt guide loops may be cracked and are not in compliance with fmvss 208.
Risk and remedy
- Risk
- The seat occupant faces increased risk of injury in theevent of a sudden stop or accident.
- Remedy
- Install reinforcing plates on the cracked shoulder belt guides.
- Filed by
- GENERAL MOTORS CORP.
1991 (1)
Front shoulder safety belt webbing may separate AT front belt upper guide loops on either side of the front seat.
Risk and remedy
- Risk
- Webbing separation could occur without prior warning andincrease the risk of injury to belted front outboard occupants in a high energycrash.
- Remedy
- Install a controlled rotation bracket on driver and passenger side front seat belt guide loops.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1991 Buick Regal have?
NHTSA lists 6 recalls for the 1991 Buick Regal.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.