Buick · Roadmaster

1994 Buick Roadmaster Recalls

Large car · RWD · Premium

There are 5 safety recalls on file for the 1994 Buick Roadmaster, filed between March 1994 and January 1996. Each one is repaired free by a franchised Buick dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1994 Roadmaster is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1996 (1)

96V019000 Filed Jan 30, 1996 308 vehicles

Lower ball joint

Defective lower control arm ball joint attachment nuts were not properly torqued and CAN loosen.

Risk and remedy
Risk
If the lower control arm ball joint loosens, fatigues and separates from the front suspension knuckle, it could cause loss of vehicle control.
Remedy
Dealers will inspect both front lower control arm ball joint attachment nuts for proper torque. If the ball joint has loosened from the knuckle, both the ball joint and the knuckle will be replaced.
Filed by
GENERAL MOTORS CORP.

1995 (1)

95V082000 Filed Apr 24, 1995 87,039 vehicles

Springs

These vehicles fail to conform to fmvss no. 124, "accelerator control systems." AT low temperatures, excessive friction CAN occur in the accelerator pedal assembly.

Risk and remedy
Risk
Consequence of non-compliance: in the event of a failure of the trottle return spring, if there is excessive friction in the pedal assembly, the engine speed may not return to idle increasing the potential for a vehicle crash.
Remedy
Dealers will replace the accelerator pedal assembly.
Filed by
GENERAL MOTORS CORP.

1994 (3)

94V210000 Filed Oct 25, 1994 130,581 vehicles

Mounting

The fuel tank attachment strap fasteners were not properly tightened. The fasteners CAN completely detach, eventually allowing the fuel tank to sag and the bottom of the tank to strike the roadway.

Risk and remedy
Risk
This CAN result in a fuel tank leak and fire if the leaking fuel is exposed to a source of ignition.
Remedy
Dealers will retighten the fuel tank strap fasteners.
Filed by
GENERAL MOTORS CORP.
94V076000 Filed Apr 16, 1994 139 vehicles

Lugs/nuts/bolts/studs

Paint on the wheel mounting surfaces CAN act as a shim between the wheel and the rotor/drum. As the vehicle is driven, the wheel imbeds into the paint, loosening the lug nut and causing a loss of clamp load.

Risk and remedy
Risk
Once clamp load is lost, all tire loads are taken by the wheel studs resulting in a fracture of the wheel studs. This could cause the wheel to separate from the vehicle and could result in a vehicles crash without prior warning.
Remedy
Dealers will clean the wheel mounting surfaces for all four wheels. Also, the wheel studs will be inspected for damage and will be replaced as necessary.
Filed by
GENERAL MOTORS CORP.
94V049000 Filed Mar 21, 1994 8,475 vehicles

Hoses/lines/piping/fittings

The engine oil cooler inlet hose may have been installed too close to the steering gear causing chafing. The chafing CAN eventually wear through the hose's protective sleeve resulting in engine oil leaking onto the engine.

Risk and remedy
Risk
If this occurs, the oil leak onto the engine CAN result in an engine compartment fire.
Filed by
GENERAL MOTORS CORP.

Recall questions

How many recalls does the 1994 Buick Roadmaster have?

NHTSA lists 5 recalls for the 1994 Buick Roadmaster.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.