There are 4 safety recalls on file for the 1996 Buick Skylark,
filed between October 1996 and March 2002.
Each one is repaired free by a franchised Buick dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1996 Skylark is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2002 (1)
02V070000
Filed Mar 6, 2002 1,589,948 vehicles
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Risk and remedy
- Risk
- If the switch is damaged, a fire could occur in the steering column, even with the engine off and the key removed.
- Remedy
- Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch. Owner notification began march 27, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, pontiac AT 1-800-762-2737, buick AT 1-800-521-7300, or oldsmobile AT 1-800-442-6537.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 02008)
1998 (1)
98V027000
Filed Feb 17, 1998 249,420 vehicles
Vehicle description: passenger vehicles. These vehicles were built with the potential for the interior lamps to come on unexpectedly while the vehicles are being driven. This does not meet the requirements of fmvss no. 101, "controls and displays."
Risk and remedy
- Risk
- The interior lamps coming on unexpectedly could startle a driver causing a momentary loss of control increasing the risk of a vehicle accident.
- Remedy
- Dealers will run a diagnostic test on the lamp control module and, if necessary, replace it.
- Filed by
- GENERAL MOTORS CORP.
1996 (2)
The steering column lower pinch bolt was not properly tightened during assembly.
Risk and remedy
- Risk
- An undertorqued pinch bolt CAN rattle and cause looseness in the steering system. If the pinch bolt backed out of the joint completely, rotation of the steering shaft against the connector could cause increasing looseness in the steering system and result in loss of steering and an accident.
- Remedy
- Dealers will inspect the steering column pinch bolt for correct torque and, if necessary, tighten the bolt to the specified torque.
- Filed by
- GENERAL MOTORS CORP.
During deployment of the passenger air bag, the air bag fabric CAN snag on a reinforcement inside the instrument panel, causing the expanding air bag to lift the instrument panel pad and then deploy under the instrument panel instead of through the door in the instrument panel.
Risk and remedy
- Risk
- In a crash, the front seat passenger could receive more severe injuries if he or she contacts a broken reinforcement or if the snagging affects the deployment of the air bag.
- Remedy
- Dealers will inspect the instrument panel pads and, if necessary, install a plastic edge protector to the instrument panel pad reinforcement. On certain early-production vehicles, the instrument panel pad will be replaced.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1996 Buick Skylark have?
NHTSA lists 4 recalls for the 1996 Buick Skylark.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.