Owners of the 2004 Cadillac CTS have reported 14 steering problems to NHTSA, 6% of all complaints about this model year.
Where owners named a specific part, the most common were hydraulic power assist system (1), rack and pinion (1), and linkages (1).
The typical report came at around 65,000 miles, and complaints were filed between June 2004 and September 2024.
These steering complaints include 1 crash.
For comparison, the 2003 CTS has the most steering complaints of any year, with 28.
Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.
1 recall for this model year involves the steering.
If your problem matches, a dealer repairs it free under the recall.
Complaints14
Typical mileage65k
Crashes / fires1 / 0
Injuries0
Parts named in these complaints
Hydraulic Power Assist System1
Rack And Pinion1
Linkages1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SteeringFiled Sep 2024CA
I am writing regarding a recent incident regarding the left front control arm of our 2004 CTS Cadillac. There was a recall for the lower control arm ball nut/washer attaching the control arm, which could lead to disengagement of the control arm, disengagement of the wheel and tire, and possible crash. We purchased the car in 2015. The Cadillac Service Center in Beverly Hills confirmed that they have records showing the car was inspected, and the recalled piece replaced in 2006. The dealer at that time was named Martin Cadillac.
Owner complaint 11612149 filed with NHTSA
SteeringFiled Jul 2024CA
Recent incident regarding the left front control arm of our 2004 CTS Cadillac. There was a recall for the lower control arm ball nut/washer attaching the control arm, which could lead to disengagement of the control arm, disengagement of the wheel and tire, and possible crash. We purchased the car in 2015. The Cadillac Service Center in Beverly Hills confirmed that they have records showing the car was inspected, and the recalled piece replaced in 2006. The dealer at that time was named Martin Cadillac.
On certain passenger vehicles involved in this campaign, the lower control arm ball stud nut/washer assemblies with washers were made of the wrong material. The washers may fracture and become loose or fall away from the vehicle, reducing clamp load. Separation of the control arm ball stud and steering knuckle, due to disengagement of the tapered attachment and retaining nut, is possible.
Risk and remedy
Risk
If the control arm separates from the knuckle, the affected corner of the vehicle will drop and the control arm would be forced downward, contacting the wheel. The affected wheel could tilt outward and create a dragging action that would tend to slow the vehicle and create a tendency for the vehicle to turn in the direction of the affected wheel. In extreme situations, the affected wheel assembly could separate from the vehicle. Separation of the wheel assembly would also sever that wheel;s hydraulic brake hose and result in diminished braking performance of the vehicle, which could result in a crash.
Remedy
Dealers will inspect the ball stud joints and measure the torque of the nut for all front lower control arms in all models affected as well as the rear lower control arms on the xlr and corvette. If the torque is not AT specification, the dealers will replace the ball stud, the knuckle, and the nut. If the torque is AT specification, the dealers will replace the nut/washer assembly only. The recall will begin on august 25, 2004. Owners should contact cadillac AT 1-866-982-2339 or chevrolet AT 1-800-630-2438.