Owners of the 1992 Chevrolet Beretta have reported 5 lighting problems to NHTSA, 10% of all complaints about this model year.
Where owners named a specific part, the most common were turn signal (4) and headlights (1).
The typical report came at around 19,000 miles, and complaints were filed between April 1995 and April 2004.
These lighting complaints include 1 fire.
For comparison, the 1991 Beretta has the most lighting complaints of any year, with 12.
Headlights, taillights, brake lights, turn signals and interior lighting, including bulbs, housings and wiring.
1 recall for this model year involves the lighting.
If your problem matches, a dealer repairs it free under the recall.
Complaints5
Typical mileage19k
Crashes / fires0 / 1
Injuries0
Parts named in these complaints
Turn Signal4
Headlights1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
LightsFiled Apr 200420,000 milesNY
The lever used to engage the high and low beam broke three times without excessive force being applied. When the lever broke it disengaged the cruise control and the light remained on.
Owner complaint 10055886 filed with NHTSA
LightsFiled Aug 200318,570 milesWIFire
While driving a column of smoke developed from the top of the steering column, directly in front of the driver. This occurred approximately one mile after noticing that the turn signal did not seem to operate properly during a turn. The smoke was also accompanied by the smell of an electrical fire. Immediately stopping the car and turning off the ignition stopped the smoke. The car was then driven approximately 5-10 miles to the dealer with no further smoke. The Chevrolet dealer stated that the problem was caused by the turn signal switch shorting out. The switch was then replaced.
The service brake stop lamp switch becomes inoperative.
Risk and remedy
Risk
The inoperative stop lamp switch will not illuminate thestop lamps when the brake pedal is depressed. This would not adequately informother drivers of the vehicle operator's intent to stop or slow down.
Remedy
Replace the stop lamp switch and correct the wiring in the connector of the stop lamp switch wiring harness.