Chevrolet · Blazer

1991 Chevrolet Blazer Recalls

Special purpose vehicle · 4WD/AWD · Regular

There are 4 safety recalls on file for the 1991 Chevrolet Blazer, filed between June 1991 and July 1999. Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1991 Blazer is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1999 (1)

99V193000 Filed Jul 19, 1999 1,125,749 vehicles

Antilock/traction control/electronic limited slip

Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.

Risk and remedy
Risk
If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
Remedy
Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Filed by
GENERAL MOTORS CORP. (manufacturer number 99041)

1996 (1)

96V142000 Filed Jul 31, 1996 97,351 vehicles

Rear/other

These vehicles exhibit a condition in which a rear seat belt buckle release button CAN stick in the unlatched (down) position under certain conditions because the buckle assembly CAN move inside the seat belt cover. If the cover moves far enough, it CAN create an interference condition with the latch release button. When it does, the seat belt buckle cannot be latched.

Risk and remedy
Risk
The rear belts may not hold an occupant in the event of a vehicle accident increasing the risk of pesonal injury.
Remedy
Dealers will replace the three rear-seat belt buckles (one assembly) with a new, revised design.
Filed by
GENERAL MOTORS CORP.

1993 (1)

93V119000 Filed Aug 2, 1993 341,364 vehicles

Disc rotor

Severe corrosion due to road salt AT the joint of the stamped steel center section and the cast outer section CAN cause the sections to separate.

Risk and remedy
Risk
Separation of the rotor sections CAN cause loss ofbraking ability in the affected wheel. This could result in increased stoppingdistance and/or loss of vehicle control and an accident.
Remedy
Replace the front brake rotors with new rotors with a corrosion protection coating. However, if replacement of brake linings are necessary, it will be done AT owner's expense since brake linings are normal maintenance items.
Filed by
GENERAL MOTORS CORP.

1991 (1)

91V108000 Filed Jun 21, 1991 102,885 vehicles

Storage

Vehicles have been shipped with the fuel tank sender seal out of position.

Risk and remedy
Risk
In the event of rollover accident, an out of postionseal could allow fuel spillage in excess of the amount prescribed by fmvss 301.spilled fuel could ignite near an ignition source.
Remedy
Replace sender seals.
Filed by
GENERAL MOTORS CORP.

Recall questions

How many recalls does the 1991 Chevrolet Blazer have?

NHTSA lists 4 recalls for the 1991 Chevrolet Blazer.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.