1996 Chevrolet Impala Problems
Model year 1996
Owners have filed 88 complaints about the 1996 Chevrolet Impala with NHTSA's vehicle safety hotline and website. The visibility and wipers leads with 13, then the steering with 12. Reports for this year mention 2 crashes and 2 fires.
One complaint can name more than one system, so the groups below add up to more than the total. Open a group for the parts owners name, the mileage and their own words.
- Visibility and wipers 15% of complaints · median 25,000 miles · Defroster/Defogger/Hvac System 13
- Steering 14% of complaints · median 40,000 miles · Hydraulic Power Assist System 12
- Electrical system 13% of complaints · median 93,000 miles · Wiring 11
- Transmission and drivetrain 13% of complaints · Driveline 11
- Engine 11% of complaints · Engine 10
- Fuel system 10% of complaints · median 88,000 miles · Storage 9
- Tires 9% of complaints · Sidewall 8
- Brakes 8% of complaints · Antilock/Traction Control/Electronic Limited Slip 7
- Suspension 7% of complaints · median 50,000 miles · Front 6
- Wheels 5% of complaints · median 23 miles · Rim 4
- Seat belts 5% of complaints · median 39,000 miles · Front 4
- Other or unknown 3% of complaints 3
- Body and structure 2% of complaints · Body 2
- Speed control 2% of complaints 2
- Seats 1% of complaints · Front Assembly 1
- Lights 1% of complaints · Headlights 1
- Air bags 1% of complaints · Frontal 1
Latest owner reports
Tl* the contact owned a 1996 Chevrolet Impala. The contact received a recall notice for NHTSA campaign number: 14v355000 (electrical system). While driving 50 MPH, the vehicle stalled and crashed into a ditch. There were no injuries and a police report was filed. The vehicle was destroyed. The manufacturer was not notified. The failure mileage was unknown.
Fuel pump fuse blow out. The car cuts off and stops while driving, blowing out the fuse. When a new fuse is installed and the engine is started, it blows out again. The problem is caused by a faulty wiring harness to the fuel pump assembly. The wiring on the fuel pump sender unit melts and peels back the insulation, causing the bare wires to touch and short against themselves or ground out against the car. This occurs right AT the top of the fuel pump tank on the sender assembly or just inside the tank.
(1) while traveling thru laughlin, nv traveling west on hwy 163, car abruptly quits. Fuel pump fuse blown. Suspect dying fuel pump. Install new fuse, travel another 30 miles up hwy 95...car dies again. This time, no blown fuse. Fuel pump will not run. Tow vehicle to final destination (las vegas). (2) pulled the tank, removed the sending unit for pump replacement. Quickly noticed the problem. The fuel pump wiring inside the tank had shorted out. Insulation burnt completely off of the primary pump power wire and shorted into the fuel quantity ground wire. Connector AT top of sending unit melted.
(1) while traveling thru laughlin, nv traveling west on hwy 163, car abruptly quits. Fuel pump fuse blown. Suspect dying fuel pump. Install new fuse, travel another 30 miles up hwy 95...car dies again. This time, no blown fuse. Fuel pump will not run. Tow vehicle to final destination (las vegas). (2) pulled the tank, removed the sending unit for pump replacement. Quickly noticed the problem. The fuel pump wiring inside the tank had shorted out. Insulation burnt completely off of the primary pump power wire and shorted into the fuel quantity ground wire. Connector AT top of sending unit melted.