Chevrolet · Malibu

1998 Chevrolet Malibu Steering Problems

Midsize car · FWD · Regular

Owners of the 1998 Chevrolet Malibu have reported 74 steering problems to NHTSA, 8% of all complaints about this model year.

Where owners named a specific part, the most common were rack and pinion (27), hydraulic power assist system (9), and hydraulic power assist (5).

The typical report came at around 83,000 miles, and complaints were filed between September 1998 and January 2016.

These steering complaints include 8 crashes, 3 injuries, and 2 deaths.

For comparison, the 2006 Malibu has the most steering complaints of any year, with 812.

Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.

1 recall for this model year involves the steering. If your problem matches, a dealer repairs it free under the recall.
Complaints74
Typical mileage83k
Crashes / fires8 / 0
Injuries3

Parts named in these complaints

  • Rack And Pinion27
  • Hydraulic Power Assist System9
  • Hydraulic Power Assist5
  • Column3
  • Linkages3
  • Column Locking3

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Steering Filed Jan 2016 200,116 miles CA

While backing out of my drive way to the right I heard loud clunking and then finally a pop as I turned the steering to the left. Immediately following, while driving in residential area left turns became extremely difficult to make, and I noticed the steering wheel seemed to be off center. I decided to make a 3-point turn to return home, and while backing to the left there seemed to be little actual movement before I felt as if the front end of the car raised a bit followed by another lout pop. Returning the wheels right saw little movement AT first before turning as normal.

Owner complaint 10818472 filed with NHTSA
Steering Filed Oct 2015 32,000 miles TN

I purchased new tires today and the technicians noticed there was excessive play in the steering link via the rack and pinion. Upon further investigation it was discovered that the welds (which are both factory and most likely robotic) holding the nut through the rack and pinion have failed. These welds are not a consumable or an otherwise replaceable part of the car and unacceptable for them to fail. Currently if the nut that was originally welded in place comes off I will completely lose steering on the drivers side. AT even slow speeds this could be fatal to the driver and occupants.

Owner complaint 10780255 filed with NHTSA
Steering Filed Oct 2014 100,000 miles KY Crash

My granddaughter was 18 years old and had recently graduated high school. She was driving to work on a Tuesday morning, the weather was clear and the road was dry. As she rounded a small curve, her steering went out. The car's right front wheel went off the road, sending the car out of control. When my granddaughter tried to steer back onto the road, the car slid on the pavement, spun around, was thrown over a ditch, hit a tree and landed back on the road. The airbag did not deploy, and my granddaughter's small body (98 pounds) was thrown across the seat and into the floorboard on the passenger side.

Owner complaint 10643381 filed with NHTSA

Related recalls

03V527000 Filed Dec 11, 2003 750,283 vehicles

Rack and pinion

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick AT 1-866-608-8080; chevrolet AT 1-800-630-2438; oldsmobile AT 1-800-630-6537; or pontiac AT 1-800-620-7668.
Filed by
GENERAL MOTORS CORP. (manufacturer number 03062)

Steering complaints across Malibu years

Questions about steering problems

How common are steering problems on the 1998 Chevrolet Malibu?

74 owners have reported steering problems to NHTSA, 8% of all complaints for this model year.

Is there a recall for steering problems on the 1998 Chevrolet Malibu?

Yes. 1 recall for this model year concerns the steering: 03V527000.