There are 4 safety recalls on file for the 1991 Chevrolet P3,
filed between July 1991 and September 1992.
Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1991 P3 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1992 (1)
The 19.5 x 6 front steel wheel disc cracks outside the mounting bolt circle and ends AT the hub's diameter.
Risk and remedy
- Risk
- If the cracking goes unnoticed, the center portion of thedisc will crack completely and eventually the rim portion of the wheel couldseparate from the center section which could result in a vehicle crash.
- Remedy
- Replace all six (seven if there is a spare) defective wheels with newly designed wheels.
- Filed by
- GENERAL MOTORS CORP.
1991 (3)
Some chassis were shipped to body builders with damaged fill or vent opening caps on the right-hand side. If a left-hand fill system was installed on the tank, and there was a damaged right-hand cap, the fuel system would not be sealed.
Risk and remedy
- Risk
- If the fuel system is not sealed, the automatic shut-offsystem used in gas stations would not work, allowing gas to be forced out ofthe defective right-hand opening. The spilled gasoline would result in a firehazard if exposed to a source of ignition.
- Remedy
- Install new caps on the vehicles with unused right-hand fill or vent openings.
- Filed by
- GENERAL MOTORS CORP.
The automatic apply transmission mounted parking brake lever pivot bolt "finger" may be loose.
Risk and remedy
- Risk
- The loose pivot bolt could allow the parking brakes torelease after they have been set manually; if the bolt falls off when theautomatic apply parking brake is set, there is insufficient braking to hold thevehicle if it is parked on an incline. Both of these conditions could result invehicle movement without prior warning and possibly in an accident.
- Remedy
- Torque pivot bolt to specifications.
- Filed by
- GENERAL MOTORS CORP.
Brakes may have missing rear axle outer bearing retaining ring and or greater than specified bearing end play. Either condition allows the rotor and hub assembly to shift position relative to the spindle. This movement CAN cause brake caliper piston recede farther than normal into the piston bore which would require greater than normal brake fluid displacement when the service brakes are applied.
Risk and remedy
- Risk
- This condition leads to increased stopping distance, andshould minimum stopping distance be required, it could result in an accidentwithout warning.
- Remedy
- Replace both rear axle hubs.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1991 Chevrolet P3 have?
NHTSA lists 4 recalls for the 1991 Chevrolet P3.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.