There are 5 safety recalls on file for the 1999 Chevrolet Silverado,
filed between October 1998 and March 2006.
Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1999 Silverado is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2006 (1)
Certain pickup trucks have galvanized-braided-steel tailgate support cables used to support the tailgate in the full open (horizontal) position. Over time these cables CAN corrode and fracture when loads are applied to them.
Risk and remedy
- Risk
- If one cable fractures, the remaining cable may retain the tailgate in a horizontal position. If both cables fracture, the tailgate would drop and strike the top surface of the rear bumper. If anyone is sitting or standing on the horizontal surface of the tailgate when both cables fractured, they could fall and be injured. On vehicles without a bumper, the tailgate may drop to a lower position.
- Remedy
- Dealers will replace the galvanized support cables with stainless steel support cables. In addition, dealers are to inspect the tailgate hinge and replace it, if necessary. The recall is expected to begin during april 2006. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 06019)
2005 (2)
05V379000
Filed Aug 29, 2005 1,353,718 vehicles
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Risk and remedy
- Risk
- This CAN cause increased stopping distances during low-speed brake applications, which could result in a crash.
- Remedy
- Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 05068)
On certain pickup trucks equipped with manual transmissions and built with either pbr parking brake systems or trw parking brake systems, the parking brake friction linings may wear to an extent where the parking brake CAN become ineffective in immobilizing a parked vehicle.
Risk and remedy
- Risk
- If the parking brake does not hold, unintended vehicle movement could occur, which could result in a crash.
- Remedy
- Dealers will install a low-force spring clip retainer for vehicles equipped with a pbr parking brake system. On vehicles equipped with the trw parking brake system, dealers will install a redesigned parking brake cable assembly. The recall began on july 29, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 05042)
2000 (1)
00V345000
Filed Oct 30, 2000 1,383,922 vehicles
Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles have a clearance condition between the front right-hand brake pipe and the body cross sill that could decrease to the point of allowing contact during the life of the vehicle. If contact occurs and the brake pipe becomes damaged, in half of the brake system there CAN be a loss of brake fluid and pressure. The brake warning lamp will be activated when the brake fluid level reaches the indicator limit.
Risk and remedy
- Risk
- During braking, the pedal will be lower than normal and stopping distances will be longer. If this occurs when stopping distance is limited, a crash could occur.
- Remedy
- Dealers will inspect the front right-hand brake pipe for wear. If there are signs of wear, this section of the brake pipe will be replaced with a new designed brake pipe section. If there are not signs of wear on the brake pipe, the dealer will install a spacer clip to ensure sufficient clearance between the brake pipe and the body cross sill.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 00093)
1998 (1)
Vehicle description: extended cab 4-wheel drive pickup trucks. Some of these vehicles have a lower than specified torque on all three of the steering gear to frame attachment bolts. The bolts CAN loosen over time allowing the steering gear to move. This loosening CAN result in some unresponsive steering feel and some noise to the driver.
Risk and remedy
- Risk
- If this condition is ignored, the steering gear to frame CAN wear and/or fatigue the attaching bolts to the point of breakage or the bolts backing out. If all the bolts break or back out, the steering gear would separate from the frame resulting in a loss of steering control.
- Remedy
- Dealers will retorque the steering gear to frame bolts to proper specifications.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1999 Chevrolet Silverado have?
NHTSA lists 5 recalls for the 1999 Chevrolet Silverado.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.