Owners of the 1992 Chevrolet Suburban have reported 146 brakes problems to NHTSA, 77% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (127), foundation components (27), and pedals and linkages (2).
Complaints were filed between February 1995 and January 2003.
These brakes complaints include 35 crashes, 1 fire, and 13 injuries.
For comparison, the 1994 Suburban has the most brakes complaints of any year, with 581.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 2001TXCrash
When I bought the truck used (85000 mls)it had a bad front end idler link and a bad A/C clutch bearing. Not long after I bought it I had to replace the alternator. I also noticed that the brakes didn't stop the vehicle like they should and I was scared to let my wife drive it because of the spongy brakes. I took it in several times to different shops and also the dealer to have them look AT the brakes and was always told that the brakes on this model were just that way. I put new rotors and pads on the front and new rear drums and shoes and repeatedly bled the system with slight improvement.
Owner complaint 749530 filed with NHTSA
BrakesFiled Aug 2000FL
While driving 65mph heard & felt a bumping against vehicle. Stopped & checked vehicle. Noticed tires were blistered & tread was pulling from the casing. Both front & rear tires were showing tread problems. Not positive if original tires AT time of purchase were used. Also, ABS brake light comes on and stays. When braking vehicle would pull immediately to the left. Vehicle was controllable.
Owner complaint 867215 filed with NHTSA
BrakesFiled Jan 2000ORCrash
ABS braking system malfunctioned, causing extended stopping distance which resulted in a crash. The brake manufacturer is aware of the problem but has yet to fix it.
Severe corrosion due to road salt AT the joint of the stamped steel center section and the cast outer section CAN cause the sections to separate.
Risk and remedy
Risk
Separation of the rotor sections CAN cause loss ofbraking ability in the affected wheel. This could result in increased stoppingdistance and/or loss of vehicle control and an accident.
Remedy
Replace the front brake rotors with new rotors with a corrosion protection coating. However, if replacement of brake linings are necessary, it will be done AT owner's expense since brake linings are normal maintenance items.
The pivot bolt holding the brake pedal to its support bracket may be improperly tightened and may not have engaged the locking material on the bolt. The bolt CAN disengage from the nut.
Risk and remedy
Risk
If the pivot bolt disengages from the nut while thevehicle is in motion, there will be a loss of brake control and could result ina vehicle accident.
Remedy
Dealers should inspect the hand started brake pedal bolts and torque them to specification.