Owners of the 1997 Chevrolet Venture have reported 76 steering problems to NHTSA, 18% of all complaints about this model year.
Where owners named a specific part, the most common were rack and pinion (46), steering wheel/handle bar (8), and hydraulic power assist system (8).
The typical report came at around 83,000 miles, and complaints were filed between June 1997 and August 2017.
These steering complaints include 1 crash and 1 death.
No other Venture year has as many steering complaints.
Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.
1 recall for this model year involves the steering.
If your problem matches, a dealer repairs it free under the recall.
Complaints76
Typical mileage83k
Crashes / fires1 / 0
Injuries0
Parts named in these complaints
Rack And Pinion46
Steering Wheel/Handle Bar8
Hydraulic Power Assist System8
Linkages3
Column Locking3
Hydraulic Power Assist2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SteeringFiled Aug 201758,000 milesMD
Steering locked up on '97 Venture van while being operated AT 70 MPH on a straight highway. Vehicle had to be towed, rack and pinion and steering pump replaced.
Owner complaint 11013139 filed with NHTSA
SteeringFiled Mar 2009120,000 milesCA
Needs replaced frontend hubs ,tierod,pinion repairs/recall this van needs a new owner!!! Nothing but costly repairs chevy needs to recall all them ventures.
Owner complaint 10261898 filed with NHTSA
SteeringFiled Jan 2008100,197 milesIL
Tl*the contact owns a 1997 Chevrolet Venture. The contact stated that the manufacturer was not going to honor the recall for the steering rack and pinion because her VIN was not included. While making a right turn AT 5 MPH, the steering wheel locked. The failure occurs intermittently. According to the NHTSA manufacturer notices to dealers (etc rcmn-02v286-8630.pdf), the VIN was included in the recall. The dealer stated that they could not find a recall for the steering rack and pinion. The powertrain and recall number were unknown. The current mileage was 160,000 and failure mileage was 100,197.
Certain passenger vehicles and mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.
Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began january 24, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, pontiac AT 1-800-762-2737, or oldsmobile AT 1-800-442-6537.