Chrysler · Cirrus

1995 Chrysler Cirrus Suspension Problems

Midsize car · FWD · Regular

Owners of the 1995 Chrysler Cirrus have reported 40 suspension problems to NHTSA, 11% of all complaints about this model year.

Where owners named a specific part, the most common were front (39) and rear (2).

The typical report came at around 94,000 miles, and complaints were filed between November 1996 and November 2008.

These suspension complaints include 1 crash, 1 fire, and 1 injury.

No other Cirrus year has as many suspension complaints.

Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.

1 recall for this model year involves the suspension. If your problem matches, a dealer repairs it free under the recall.
Complaints40
Typical mileage94k
Crashes / fires1 / 1
Injuries1

Parts named in these complaints

  • Front39
  • Rear2

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Suspension Filed Nov 2008 75,500 miles FL

Tl*the contact owns a 1995 Chrysler Cirrus. Several months ago, while driving 20 MPH, the driver's side front suspension began making a creaking noise. The noise did not sound like the springs, but more like plastic rubbing over a heavy load. The contact took the vehicle to a mechanic and was informed that both the passenger and driver's side front suspension were out of lubricant. In addition, the suspension joints needed to be replaced. After researching the issue, the contact discovered NHTSA campaign ID number 97v201000 (suspension:front:control arm:lower ball joint) for the same failure his vehicle was experiencing.

Owner complaint 10248559 filed with NHTSA
Suspension Filed May 2006 122,150 miles PA

I've had my engine checked back in may of 05 by the dealer they said it was engine misfire,the distributor ignition was bad. They charged me $321 just to check it,then I paid $276 to get it fixed. The car has had a drip ever since. In the past 6 to 8 months or longer I've had a drip from the engine that CAN't be fixed , I recently had my car worked on it was in the shop for a month it cost me $2500 to repair and it still has a leak. It's back there again because it needs that expansion plug and retaining bracket that only the dealer CAN provide according to every site but the place the car comes from.

Owner complaint 10156496 filed with NHTSA
Suspension Filed Sep 2005 OR

1995 Chrysler Cirrus castle nut and pin fell off allowing the upper control arm to fall apart.*mr this failure resulted in hundreds of dollars in damage. After the failure, the consumer received a recall notice on this problem and had it repaired. After the repairs the part failed again. *nm updated 9/15/05.

Owner complaint 10136705 filed with NHTSA

Related recalls

97V201000 Filed Nov 13, 1997 599,000 vehicles

Lower ball joint

Vehicle description: passenger vehicles. The lower control arm ball joint CAN separate due to loss of lubrication.

Risk and remedy
Risk
Separation of the ball joint could cause a loss of steering control increasing the risk of a vehicle crash.
Remedy
Dealers will inspect the ball joint end housing cover seal for leakage with a high pressure air tester and the rubber boot will be visually inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.
Filed by
CHRYSLER CORPORATION

Suspension complaints across Cirrus years

Questions about suspension problems

How common are suspension problems on the 1995 Chrysler Cirrus?

40 owners have reported suspension problems to NHTSA, 11% of all complaints for this model year.

Is there a recall for suspension problems on the 1995 Chrysler Cirrus?

Yes. 1 recall for this model year concerns the suspension: 97V201000.