Chrysler · Cirrus

1996 Chrysler Cirrus Recalls

Midsize car · FWD · Regular

There are 7 safety recalls on file for the 1996 Chrysler Cirrus, filed between January 1996 and January 2004. Each one is repaired free by a franchised Chrysler dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1996 Cirrus is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

2004 (1)

04V021000 Filed Jan 13, 2004 2,315,768 vehicles

Floor shift

On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.

Risk and remedy
Risk
Either circumstance may result in the vehicle rolling away without warning.
Remedy
Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on june 14, 2004. Owners should contact daimlerchrysler AT 1-800-853-1403.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number C45)

1998 (1)

98V183000 Filed Aug 6, 1998 685,000 vehicles

Park/neutral start interlock switch

Vehicle description: passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key CAN cause a trapped key condition which CAN result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, CAN break the connecting pin in the shifter.

Risk and remedy
Risk
If this happens, the "ignition-park" interlock system will be nonfunctional.
Remedy
Dealers will inspect for proper operation of the system. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a "self-adjusting" design.
Filed by
CHRYSLER CORPORATION

1997 (2)

97V201000 Filed Nov 13, 1997 599,000 vehicles

Lower ball joint

Vehicle description: passenger vehicles. The lower control arm ball joint CAN separate due to loss of lubrication.

Risk and remedy
Risk
Separation of the ball joint could cause a loss of steering control increasing the risk of a vehicle crash.
Remedy
Dealers will inspect the ball joint end housing cover seal for leakage with a high pressure air tester and the rubber boot will be visually inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.
Filed by
CHRYSLER CORPORATION
97V095000 Filed Jun 6, 1997 219,000 vehicles

Hinge and attachments

Vehicle description: passenger vehicles. The secondary hood latch spring CAN disengage from its retention hole if the hood is slammed shut.

Risk and remedy
Risk
If this condition occurs simultaneously without engaging the primary latch, the hood would not be restrained increasing the risk of a vehicle crash.
Remedy
Dealers will replace the secondary hood latch spring with a longer end hook spring.
Filed by
CHRYSLER CORPORATION

1996 (3)

96V075000 Filed May 3, 1996 151,800 vehicles

Master cylinder

The brake master cylinder CAN leak brake fluid due to a damaged double lip rear piston seal.

Risk and remedy
Risk
Brake fluid leakage CAN result in diminished effectiveness of one half of the split brake system. The instrument panel warning light(s) will signal system impairment prior to partial brake system loss.
Remedy
Dealers will replace the rear brake master cylindr piston assembly.
Filed by
CHRYSLER CORPORATION
96V074000 Filed May 2, 1996 90,000 vehicles

Antilock/traction control/electronic limited slip

Corrosion of the ABS hydraulic control unit CAN cause the solenoid valves to stick in the open position.

Risk and remedy
Risk
If either front wheel valve sticks, the vehicle would swerve from a straight stop when the brakes are applied.
Remedy
Dealers will install a plate and silicone grease injected into the solenoid cavity to eliminate the potential for this condition.
Filed by
CHRYSLER CORPORATION
96V006000 Filed Jan 11, 1996 40,000 vehicles

Gasoline

In certain vehicles, the engine cylinder head oil galley plug does not seal properly and engine cylinder head oil is not adequately retained.

Risk and remedy
Risk
Inadequate sealing and retention of the plug CAN result in oil leakage which could cause a fire in the engine compartment.
Remedy
Dealers will install an expansion plug and retaining bracket over the cylinder head oil galley plug.
Filed by
CHRYSLER CORPORATION

Recall questions

How many recalls does the 1996 Chrysler Cirrus have?

NHTSA lists 7 recalls for the 1996 Chrysler Cirrus.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.