Owners of the 1999 Chrysler Cirrus have reported 13 transmission problems to NHTSA, 21% of all complaints about this model year.
Where owners named a specific part, the most common were automatic transmission (8) and axle assembly (1).
The typical report came at around 79,000 miles, and complaints were filed between August 1999 and February 2009.
For comparison, the 1995 Cirrus has the most transmission complaints of any year, with 66.
Automatic and manual transmissions, CVTs, clutches, axles, driveshafts and transfer cases: harsh or delayed shifts, slipping, shuddering and rolling away in park.
1 recall for this model year involves the transmission.
If your problem matches, a dealer repairs it free under the recall.
Complaints13
Typical mileage79k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Automatic Transmission8
Axle Assembly1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Transmission and drivetrainFiled Feb 200989,490 milesPA
About 2 years ago, my car began stuttering and stalling out with no warning. The oil light repeated flashes on, the check engine light flashes and then stays on, and the car wont start or just cuts off. The transmission speed sensor was replaced. The transmission was replaced. The oil was changed. This past 3 months alone, it has been AT the service department 6 times for this same problem. I AM now being told that I need a tune-up, which will cost $700, then the EGR needs replaced, and a few other things. However, when the mechanic had it last week, he could not find anything wrong with it.
Owner complaint 10259302 filed with NHTSA
Transmission and drivetrainFiled Aug 2008104,900 milesNC
I currently own a 1999 Chrysler Cirrus v6. Auto is equipped with a 41te automatic transmission with 104,000 miles on it. According to al web sites I have come to find that the 41te automatic transmission has proven to be an unreliable unit resulting in premature failure and bearing failure. Chrysler has refused to acknowledge the defect. As of this writing the pinion bearings have failed in my vehicle and Chrysler has refused to repair as this is an ongoing problem with this transmission for which the manufacturer denies an responsibility. There are thousands of people like me out there with no recourse. Estimated repair cost $2,000.00.
On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.
Risk and remedy
Risk
Either circumstance may result in the vehicle rolling away without warning.
Remedy
Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on june 14, 2004. Owners should contact daimlerchrysler AT 1-800-853-1403.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number C45)
Transmission and drivetrain complaints across Cirrus years