Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Feb 2017IDCrash
I read on the internet under 2000 Chrysler Concorde that there is a master brake issue if you don't have ABS brakes. It affects the stopping and the brakes constantly rub. That is the main concern I have with my car.
Owner complaint 10957454 filed with NHTSA
BrakesFiled Oct 200660,000 milesIL
Dt*: the contact stated that after the purchase of the vehicle there were problems with the brakes which were caused by improper installation of the brake line. The engine also made several clunky noises. The vehicle was taken to the dealer who confirmed the brakeline was installed improperly and oil sludge build up contaminated the engine causing the problems. On a second visit to the dealer the engine began to smoke indicating a blowout. The dealer determined the blow out was due to poor maintenance. The components affected were the timing chain, the control panel and the engine.
Vehicle description: non-ABS equipped passenger vehicles. The brake master cylinder piston retainer snap ring may have been bent inward during the assembly process. The master cylinder piston may be in a "brake applied" position due to the damaged piston retainer snap ring. When the piston is in the applied position, the fluid compensation ports are closed which results in a brake drag condition.
Risk and remedy
Risk
If the brake overheat, brake fading could lead to an increase in needed stopping distance. Should a driver not anticipate the extra stopping distance, this condition could cause a crash.
Remedy
Dealers will replace the brake master cylinder.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 885)