Owners of the 1990 Chrysler Imperial have reported 92 brakes problems to NHTSA, 85% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (74), foundation components (11), and power assist (3).
The typical report came at around 92,000 miles, and complaints were filed between May 1995 and February 2016.
These brakes complaints include 5 crashes and 2 injuries.
No other Imperial year has as many brakes complaints.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Feb 2016110,000 milesMI
Tl* the contact owns a 1990 Chrysler Imperial. The contact stated that while driving AT 45 MPH and exiting the highway, the brake pedal was depressed and failed to respond. The contact stated that the brakes eventually responded and the vehicle came to a stop. The vehicle was taken to a dealer where it was diagnosed that the power brake booster needed to be replaced. The repairs were not done due to the parts not being available. The manufacturer was made aware of the failure. The failure mileage was 110,000.
Owner complaint 10825120 filed with NHTSA
BrakesFiled Aug 2012150,000 milesOR
Tl* the contact owns a 1990 Chrysler Imperial. The contact stated while driving 40 MPH with the brake pedal engaged, the pedal went all the way to the floorboard and failed to slow down the vehicle. The vehicle was taken to a local mechanic who diagnosed that the ABS modular pump failed. The dealer was contacted who advised the contact that the failure was related to the recall under NHTSA campaign ID number: 96v099000 (service brakes, hydraulic: antilock) but the vehicle was not included since it was equipped with a bosch ABS system pump. The recall was specifically for the bendix ABS system pump. The vehicle was not repaired.
Owner complaint 10469498 filed with NHTSA
BrakesFiled Jun 201296,565 milesVACrash
Tl* the contact owns a 1990 Chrysler Imperial. The vehicle was repaired under NHTSA campaign ID number: 96v099000 (service brakes, hydraulic: anti-lock). The contact stated that while driving 15 MPH, and attempting to brake AT a stop sign, the braking system failed. The contact almost crashed into a school bus but instead, crashed against the curb. The anti lock braking system warning light also illuminated. The vehicle was not taken to the dealer for repairs or inspection. The manufacturer was not made aware of the failure. The current and failure mileage was 96,565. Updated 7/26/12
The ABS hydraulic control unit CAN experience excessive brake actuator piston seal wear causing pump-motor deterioration.
Risk and remedy
Risk
If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
Remedy
Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
The anti-lock brake system high pressure hose may leak or detach AT its crimped end fitting resulting in the discharge of hydraulic fluid.
Risk and remedy
Risk
Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure hose with a hose of different design and construction.