Owners of the 1990 Chrysler New Yorker have reported 46 brakes problems to NHTSA, 50% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (37), foundation components (5), and power assist (1).
The typical report came at around 81,000 miles, and complaints were filed between January 1995 and August 2009.
These brakes complaints include 1 fire and 3 injuries.
No other New Yorker year has as many brakes complaints.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 200991,000 milesOH
Tl*the contact owns a 1990 Chrysler New Yorker. The contact stated that he inserted his VIN number into the manufacturers website in which it stated that his VIN number was included in recall# 96v099000 (service brakes, hydraulic:antilock); however when he contacted the manufacturer a representative stated denied that there was an outstanding recall. To the contrary he contacted the dealer in which a technician stated that his VIN number was affected, but in order to make the repair he would have to pay $506.00 to repair the ABS accumulator. As of current date the vehicle has not been repaired. The failure and current mileages were 91,000.
Owner complaint 10282051 filed with NHTSA
BrakesFiled Apr 2006CA
1990 New Yorker air bag and ABS light illuminated, ABS pump needed to be replaced. When driving to repair shop vehicle over heated and A/C and windows were inoperative.
Owner complaint 10155155 filed with NHTSA
BrakesFiled Jan 2005CA
NHTSA campaign 96v099000; chevrolet issued a hydraulic anti-lock brake system recall. This vehicle is not included in the recall, but the consumer experienced brake failure. The VIN is outside the remedy scope. *jb recall campaign: the consumer stated that water was leaking under windshield above the heater block causing the resistor terminals to corrode. The ignition switch was replaced.
The ABS hydraulic control unit CAN experience excessive brake actuator piston seal wear causing pump-motor deterioration.
Risk and remedy
Risk
If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
Remedy
Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
The anti-lock brake system high pressure hose may leak or detach AT its crimped end fitting resulting in the discharge of hydraulic fluid.
Risk and remedy
Risk
Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure hose with a hose of different design and construction.