Chrysler · Town and Country

1991 Chrysler Town and Country Brakes Problems

Special purpose vehicle · FWD · Regular

Owners of the 1991 Chrysler Town and Country have reported 10 brakes problems to NHTSA, 40% of all complaints about this model year.

Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (9) and foundation components (1).

The typical report came at around 123,000 miles, and complaints were filed between July 1995 and June 2011.

These brakes complaints include 1 crash.

For comparison, the 2008 Town and Country has the most brakes complaints of any year, with 319.

Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.

3 recalls for this model year involve the brakes. If your problem matches, a dealer repairs it free under the recall.
Complaints10
Typical mileage123k
Crashes / fires1 / 0
Injuries0

Parts named in these complaints

  • Antilock/Traction Control/Electronic Limited Slip9
  • Foundation Components1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Brakes Filed Jun 2011 72,000 miles RI

Tl*the contact owns a 1991 Chrysler Town and Country. While the vehicle was parked the contact noticed the ABS warning light illuminated on the instrument panel. The contact also stated the ABS function was constantly on which made the vehicle difficult to drive. The dealer stated the vehicle had previously been repaired under NHTSA campaign ID number: 96v099000 (service brakes, hydraulic:antilock) and would have to be diagnosed for the failure. The contact stated prior to the recall repairs she had not experienced a failure with the vehicle. The vehicle was not repaired. The approximate failure mileage was 72,000.

Owner complaint 10407002 filed with NHTSA
Brakes Filed Feb 2008 104,000 miles IL

Tl*the contact owns a 1991 Chrysler Town and Country. While driving 30 MPH, the ABS failed to operate and the vehicle took 20-30 additional feet to stop. The ABS light illuminated intermittently. While AT the dealer on February 15, 2008, they stated that there was failure with the wiring and the vehicle needed a cylinder module and electrical work. The repair would cost approximately $200. The contact had the vehicle repaired, but the failure recurred. The dealer stated that nothing further could be done. The failure mileage was 104,000 and current mileage was 118,000.

Owner complaint 10219198 filed with NHTSA

Related recalls

96V099000 Filed Jun 13, 1996 321,000 vehicles

Antilock/traction control/electronic limited slip

The ABS hydraulic control unit CAN experience excessive brake actuator piston seal wear causing pump-motor deterioration.

Risk and remedy
Risk
If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
Remedy
Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
Filed by
CHRYSLER CORPORATION (manufacturer number 685)
92V030000 Filed Mar 10, 1992 10,492 vehicles

Hoses, lines/piping, and fittings

The anti-lock brake system high pressure pump may be porous which will result in brake fluid leakage.

Risk and remedy
Risk
Fluid leakage eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure pump and high pressure hose if the last six digits of the bar code label on the pump are between 052300 and 059262.
Filed by
CHRYSLER CORPORATION
91V191000 Filed Nov 1, 1991 80,000 vehicles

Hoses, lines/piping, and fittings

The anti-lock brake system high pressure hose may leak or detach AT its crimped end fitting resulting in the discharge of hydraulic fluid.

Risk and remedy
Risk
Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure hose with a hose of different design and construction.
Filed by
CHRYSLER CORPORATION

Brakes complaints across Town and Country years

Questions about brakes problems

How common are brakes problems on the 1991 Chrysler Town and Country?

10 owners have reported brakes problems to NHTSA, 40% of all complaints for this model year.

Is there a recall for brakes problems on the 1991 Chrysler Town and Country?

Yes. 3 recalls for this model year concern the brakes: 96V099000, 92V030000, 91V191000.