Owners of the 1998 Dodge Avenger have reported 17 suspension problems to NHTSA, 29% of all complaints about this model year.
Where owners named a specific part, the most common were front (17).
The typical report came at around 85,000 miles, and complaints were filed between January 1999 and January 2011.
These suspension complaints include 1 crash.
For comparison, the 1995 Avenger has the most suspension complaints of any year, with 59.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints17
Typical mileage85k
Crashes / fires1 / 0
Injuries0
Parts named in these complaints
Front17
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Jan 2011LA
Tl*the contact owns a 1998 Dodge Avenger. The contact stated that since 2010, both lower ball joints failed. The contact was driving 35 MPH when the driver side ball joint failed and the tire began to lean. After having the driver side repaired, the passenger side failed when the contact was driving 45 MPH, causing the contact to spin around and end up facing oncoming traffic. The contact referenced recall 00v421002 (suspension: front: control arm: lower ball joint) but had never been notified. The failure mileage was unknown. The current mileage was approximately 140,000.
Owner complaint 10376420 filed with NHTSA
SuspensionFiled Nov 2010114,000 milesOH
Tl*the contact owns a 1998 Dodge Avenger. While the contact was driving 55 MPH the vehicle hit a bump causing the lower control arm to snap and the suspension to hit the tire and the fender. The vehicle was towed. The vehicle was not inspected by a dealer nor was it repaired. The failure mileage was 114,000. Updated 01/14/11
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water CAN intrude. Also, mmc has added the potential of leaking moisture, which CAN cause the ball stud to corrode.
Risk and remedy
Risk
This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v-066.
Remedy
Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 967)