Owners of the 2007 Dodge Caliber have reported 117 speed control problems to NHTSA, 12% of all complaints about this model year.
Where owners named a specific part, the most common were accelerator pedal (10) and cruise control (1).
The typical report came at around 76,000 miles, and complaints were filed between March 2007 and May 2026.
These speed control complaints include 7 crashes, 1 fire, and 7 injuries.
No other Caliber year has as many speed control complaints.
Accelerator pedals, throttle bodies and cruise control: unintended acceleration, stuck throttles and surging.
1 recall for this model year involves the speed control.
If your problem matches, a dealer repairs it free under the recall.
Complaints117
Typical mileage76k
Crashes / fires7 / 1
Injuries7
Parts named in these complaints
Accelerator Pedal10
Cruise Control1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Speed controlFiled May 2026MA
Vehicle tipm shut off transmission while driving an cause a traffic jam on a busy intersection caused the transmission system to go in limp mode an no breaks. Was very dangerous lucky I had a hand break that worked cause engine to shut off an studder had to get towed an transported the vehicle home an got it inspected by a mobile mechanic an says the fuse box had blown internal components due to failing internal electrical components or weak points in the tipm system
Owner complaint 11736456 filed with NHTSA
Speed controlFiled Apr 2024CA
The contact owns a 2007 Dodge Caliber. The contact received notification of NHTSA Campaign Number: 10V234000 (Vehicle Speed Control) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.
Owner complaint 11585321 filed with NHTSA
Speed controlFiled Aug 2022IL
My car was slow to accelerate, and sounded like the engine was over-revving. The engine stalled several times, and the car itself was shaking, while driving at a moderate speed level, which I feared would have caused an accident, because it was sudden. The service warning light appeared. I had the manifold replaced by one mechanic, but the problem occurred again. I got a second opinion, that determined it was the throttle body assembly, which was replaced. That was three years ago. Now, the same issue has cropped up again. The cost was exorbitant, and is something I can't afford every few years.
Chrysler is recalling certain model year 2007 dodge caliber and jeep compass passenger vehicles manufactured from march 7 through may 19, 2006. The pivot bushings in vehicles with oversized accelerator pedal bearing pockets may become dislodged and potentially cause the accelerator pedal to bind or stick.
Risk and remedy
Risk
Should the pedal bind or become stuck, it CAN be overcome by smart brakes which override the accelerator pedal in certain conditions.
Remedy
Chrysler will notify owners and dealers will inspect and replace all affected accelerator pedal assemblies free of charge. The safety recall began on june 29, 2010. Owners may contact chrysler toll-free AT 1-800-853-1403.