Owners of the 2000 Dodge Intrepid have reported 31 brakes problems to NHTSA, 3% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (12), antilock/traction control/electronic limited slip (8), and power assist (1).
The typical report came at around 41,000 miles, and complaints were filed between November 1999 and April 2012.
These brakes complaints include 3 crashes, 1 fire, and 3 injuries.
For comparison, the 1994 Intrepid has the most brakes complaints of any year, with 68.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Apr 2012150 milesPA
My 2000 Intrepid s engine blew up 2 years ago and again 2days ago there was no warning. Master cylinder is failing and the steering pin broke in the car and left me helpless I ended up in a ditch. I called Dodge and they said they couldn't help because it was out of warranty past 7 years and its only been 2.
Owner complaint 10455935 filed with NHTSA
BrakesFiled Sep 200999,275 milesOH
Tl*the contact owns a 2000 Dodge Intrepid. The contact stated that during break application he hears a grinding noise. Break failure CAN lead to increased stopping distances, which increases the risk of vehicle crash. All the components in the break system were replaced. After the repair the failure resurfaced. The current and failure mileages were 99275. Bl
Owner complaint 10284489 filed with NHTSA
BrakesFiled Jul 2006120,000 milesKY
Dt*: the contact stated the vehicle hesitated intermittently before it finally stalled. Also, the brakes did not hold properly. The dealer determined the engine needed to be replaced due to sludge. The dealer also replaced the brake pads, rotors and calipers but indicated the ABS sensor also needed to be replaced.
Vehicle description: non-ABS equipped passenger vehicles. The brake master cylinder piston retainer snap ring may have been bent inward during the assembly process. The master cylinder piston may be in a "brake applied" position due to the damaged piston retainer snap ring. When the piston is in the applied position, the fluid compensation ports are closed which results in a brake drag condition.
Risk and remedy
Risk
If the brake overheat, brake fading could lead to an increase in needed stopping distance. Should a driver not anticipate the extra stopping distance, this condition could cause a crash.
Remedy
Dealers will replace the brake master cylinder.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 885)