Owners of the 1994 Dodge Ram have reported 64 electrical problems to NHTSA, 14% of all complaints about this model year.
Where owners named a specific part, the most common were ignition (44), wiring (19), and 12v/24v/48v battery (5).
The typical report came at around 88,000 miles, and complaints were filed between January 1995 and April 2003.
These electrical complaints include 19 fires and 2 injuries.
For comparison, the 1995 Ram has the most electrical complaints of any year, with 72.
Batteries, alternators, wiring, fuses, ignition, instrument clusters, infotainment and body electronics, including warning lights and parasitic drain.
1 recall for this model year involves the electrical.
If your problem matches, a dealer repairs it free under the recall.
Complaints64
Typical mileage88k
Crashes / fires0 / 19
Injuries2
Parts named in these complaints
Ignition44
Wiring19
12V/24V/48V Battery5
Starter Assembly1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Electrical systemFiled Mar 2003ARFire
There was a problem with the ignition switch, the key became hard to turn, and then all of a sudden there was a burnt wire smell coming from the steering wheel, and a burn hole was on the side of the steering wheel column, several weeks later, the consumer received a recall notice regarding the ignition switch.
Owner complaint 10011236 filed with NHTSA
Electrical systemFiled Nov 200287,608 milesFL
Consumer stated that while driving and without warning the brake line had rusted causing fluid to leak out and extend stopping distance. Ts dealership installed new brake line. Dealership stated started needed to be replaced, however consumer declined.
Owner complaint 8022330 filed with NHTSA
Electrical systemFiled Apr 2002OKFire
While traveling on highway heard a knocking noise coming from underneath the vehicle.*ak the engine wires shorted causing a fire and the vehicle burned completely, there were 2 injuries.
Vehicle description: light duty pickup trucks. The affected vehicles were built with an ignition switch and wiring that could overheat. High electrical current loads pass through the switch when the blower motor is operated on high for an extended periods of time.
Risk and remedy
Risk
This could cause the ignition switch and wiring to overheat.
Remedy
Dealers will install a relay and overlay harness.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 875)