Owners of the 1990 Ford Aerostar have reported 27 brakes problems to NHTSA, 14% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (18), antilock/traction control/electronic limited slip (15), and pedals and linkages (1).
The typical report came at around 101,000 miles, and complaints were filed between February 1995 and June 2005.
These brakes complaints include 5 crashes and 4 injuries.
For comparison, the 1993 Aerostar has the most brakes complaints of any year, with 59.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jun 200412,000 milesGA
The vehicle is experiencing the failures described in the master cylinder pistons recall 89v223000. In addition, the ABS light comes on. Also, the vehicle is experiencing the failure described in the ignition switch recall 96v071000 but this vehicle not included in recall due to VIN.
Owner complaint 10076051 filed with NHTSA
BrakesFiled Nov 2003190,000 milesOHCrash
The rear anti lock brakes have malfunctioned, causing the brakes to lock. As a result the steering lock and the vehicle lost control. No report of airbag deployment. Please provide additional information.
Owner complaint 10048473 filed with NHTSA
BrakesFiled Sep 2001MO
Master cylinder loses pressure and brake pedal goes to the floor, stops vehicle very little. Consumer may try it next time and brakes will work fine. This problem is intermittent. Consumer contacted Ford about recall on brakes. Ford stated that there were no recall on brakes. Ford file#9005975796.
Inability to maintain pressure in the secondary system of the master cylinder (controls braking of rear wheels) could increase brake pedal travel and reduce brake performance AT temperatures less than 40 degrees.
Risk and remedy
Risk
This would cause reduced braking effectiveness andincreased stopping distance that could result in a crash or collision.
Remedy
Install new design master cylinder incorporating a redesigned seal.