Owners of the 2003 Ford Escape have reported 57 brakes problems to NHTSA, 10% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (11), antilock/traction control/electronic limited slip (11), and antilock (4).
The typical report came at around 70,000 miles, and complaints were filed between February 2003 and June 2023.
These brakes complaints include 4 crashes, 9 fires, and 2 injuries.
For comparison, the 2002 Escape has the most brakes complaints of any year, with 195.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jun 2023130,000 milesPA
The contact owns a 2003 Ford Escape. The contact stated that upon starting the vehicle, and while driving at unknown speeds, the vehicle was smoking. There were no warning lights illuminated. The owner disconnected the battery. The vehicle was taken to an independent mechanic who informed the owner that the ABS module and wiring harness needed to be replaced. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 130,000.
Owner complaint 11529512 filed with NHTSA
BrakesFiled Jul 2021AR
I was recently driving on the interstate and the gas pedal got stuck so the car started speeding up very fast and the brakes and emergency brake would not make it slow down. After this i found out there was a recall about this problem and it says the previous owner of the vehicle fixed it but itâs happened while i owned it so i donât think it was fixed correctly.
Owner complaint 11423859 filed with NHTSA
BrakesFiled Jul 2020115,000 milesWAFire
Tl* the contact owns a 2003 Ford Escape. The contact stated that while entering the driveway to park, there was smoke present. The contact exited the vehicle and opened the hood when a fire was discovered. The contact grabbed a water hose and extinguished the fire. The ABS module connector was melted along with wires. AT the time of the incident the contact was pregnant and had her 4-year-old daughter in the vehicle. No injuries were sustained. The fire department was not contacted. No police report was filed. The vehicle had not been diagnosed or repaired.
On certain sport utility vehicles equipped with antilock brakes (ABS), the ABS module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.
Risk and remedy
Risk
An electrical short might cause an ABS malfunction that would illuminate the ABS warning light, and in some cases, the module may overheat resulting in burning odor, smoke, and/or fire. This condition could occur either when the vehicle ignition switch is in the off position or while the vehicle is being operated.
Remedy
Dealers will inspect the wire harness connector to the ABS module for missing or dislodged wire seals, and repair or replace the harness connector as appropriate. The dealer will also inspect the connector on the ABS module and replace it if it is found to be corroded or damaged. The recall began on april 23, 2007. Owners may contact ford AT 1-800-392-3673.