Ford · Expedition

1997 Ford Expedition Recalls

Special purpose vehicle · 4WD/AWD, RWD · Regular

There are 7 safety recalls on file for the 1997 Ford Expedition, filed between December 1996 and September 2005. Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1997 Expedition is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

2005 (1)

05V388000 Filed Sep 7, 2005 4,500,000 vehicles

Vehicle speed control

On certain pickup trucks and sport utility vehicles equipped with speed control, the speed control deactivation switch may overheat, smoke, or burn.

Risk and remedy
Risk
A fire AT the switch could occur.
Remedy
By letter dated september 12, 2005, owners were instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. Owners who have had their speed control deactivated are being notified that parts will be available and advised to make an appointment to reconnect the speed control beginning in february 2006. Owners who did not have their speed control deactivated are being notified to have their system remedied beginning in february 2006. Owners are urged to avail themselves of the free disconnect service as soon as possible because of the significant risk of fire. Owners may contact ford AT 1-800-392-3673. (note: also see recalls 05v017 and 06v286)
Filed by
FORD MOTOR COMPANY (manufacturer number 05S28)

2003 (1)

03V196000 Filed May 27, 2003 171,446 vehicles

Shaft sector

On certain pickup trucks and sport utility vehicles, if the intermediate shaft yoke separates from the steering gear input shaft, the steering system becomes disconnected.

Risk and remedy
Risk
This could result in loss of steering control, potentially resulting in a vehicle crash without warning.
Remedy
Dealers will inspect the steering intermediate shaft yoke to determine if the yoke is fully seated on the steering gear input shaft. If the yoke is fully seated no service is required. If the yoke is not fully seated and bolt groove and spline is visible, the intermediate shaft and bolt will be replaced as well as the bolt AT the steering column connection. Owner notification began on may 30, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
Filed by
FORD MOTOR COMPANY (manufacturer number 03S02)

2000 (2)

00V168000 Filed Jun 19, 2000 20,637 vehicles

Exterior lighting

Vehicle description: mini vans, light pickup trucks, and sport utility vehicles. Off lease canadian vehicles equipped with daytime running lights which meet canadian requirements and not the photometric requirements of fmvss 108, "lamps, reflective devices, and associated equipment." according to ford, the vehicles were imported into the u.s. Erroneously.

Risk and remedy
Risk
The light given off from the daytime running lights is brighter than allowed by u.s. Standards.
Remedy
Dealers will be advised to deactivate the running light function and to complete any outstanding safety recalls on these vehicles.
Filed by
FORD MOTOR COMPANY (manufacturer number 00S14)
00V073000 Filed Mar 7, 2000 565,800 vehicles

Trailer hitches

Vehicle description: multi-purpose vehicles. The trailer hitch assembly to the frame attaching bolts could lose the clamp load.

Risk and remedy
Risk
The trailer hitch could then separate from the vehicle.
Remedy
Dealers will replace the trailer hitch mounting bolts and nut plates.
Filed by
FORD MOTOR COMPANY (manufacturer number 00S05)

1998 (1)

98V095000 Filed May 13, 1998 1,520,000 vehicles

Lugs/nuts/bolts/studs

Vehicle description: multi-purpose vehicles and light duty pickup trucks. The lug nuts on these vehicles may not create sufficient clamp load allowing wheel movement in relation to the hub/rotor mounting surface.

Risk and remedy
Risk
This CAN result in the loosening of lug nuts, stud fatigue failure, and the potential for a wheel separation from the vehicle, increasing the risk of a vehicle crash.
Remedy
Owners of these vehicles will be receiving two notifications. The first notification, which began in may 1998, will provide an interim repair procedure until parts become available. This interim procedure CAN be completed by owners or their dealers. It specifies that the lug nut torque must be verified to be 100 lbs. Then the lug nuts need to be tightened an additional 1/8 to 1/4 turn more. There will be a second owner notification, which is expected to begin july 20, 1998, under which dealers will inspect the wheel studs and replace the wheel lug nuts.
Filed by
FORD MOTOR COMPANY

1997 (1)

97V171000 Filed Oct 7, 1997 866,000 vehicles

Gear position indication (prndl)

Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. If the automatic transmission shift cable assembly was not fully attached to the steering column bracket, the shift cable assembly CAN come out of the bracket. The vehicle operator would then not be able to shift the transmission from one of the drive gear positions into the park position even though the gear shift selector would indicate "park."

Risk and remedy
Risk
The condition would not allow a disengagement of the transmission from the park position or affect proper neutral start switch operation. Unintended vehicle movement could occur if the parking brake was not set.
Remedy
Dealers will make the proper attachment of the transmission shift control cable to the steering column bracket and add a tie strap to that connection.
Filed by
FORD MOTOR COMPANY

1996 (1)

96V252000 Filed Dec 18, 1996 25,000 vehicles

Suspension rear

The rear axle track bar bracket CAN separate from the frame due to missing welds or inadequate weld penetration.

Risk and remedy
Risk
If both brackets separate, the rear axle CAN move laterally until the tires contact either the frame or the wheelhouse resulting in either tire damage or a significant reduction in vehicle handling performance.
Remedy
Dealers will install a track bar bracket reinforcement kit and inspection of the axle tubes. The suspect axle tubes do not have a stamped date code on the tube. Axles without date codes on the tubes will be replaced.
Filed by
FORD MOTOR COMPANY

Recall questions

How many recalls does the 1997 Ford Expedition have?

NHTSA lists 7 recalls for the 1997 Ford Expedition.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.