1996 Ford Explorer Transmission and drivetrain Problems
Special purpose vehicle · 4WD/AWD, RWD · Regular
Owners of the 1996 Ford Explorer have reported 120 transmission problems to NHTSA, 8% of all complaints about this model year.
Where owners named a specific part, the most common were automatic transmission (89), driveline (18), and manual transmission (7).
The typical report came at around 131,000 miles, and complaints were filed between January 1996 and August 2013.
These transmission complaints include 5 crashes, 1 fire, and 2 injuries.
For comparison, the 2002 Explorer has the most transmission complaints of any year, with 1,502.
Automatic and manual transmissions, CVTs, clutches, axles, driveshafts and transfer cases: harsh or delayed shifts, slipping, shuddering and rolling away in park.
Parts named in these complaints
- Automatic Transmission89
- Driveline18
- Manual Transmission7
- Axle Assembly5
- Clutch Assembly2
- Axle Hubs1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Driving truck down wisconsin avenue in appleton when truck refused to shift. Immediately brought truck into to wisconsin motors sales and service and was informed the transmission had failed in truck. Truck had just been purchased ten days earlier.
The vehicle began hesitating during takeoff, allowing the engine to experience high RPM's but very little acceleration. The vehicle then began to not fall into 1st gear, when you shifted the car into drive from park the vehicle would hesitate for about 4 seconds then lurch heavily, the vehicle also does this AT every stop, after you make a complete stop and precede to attempt to drive again the vehicle will RPM as you push the accelerator but won't move for about 4 seconds, after the 4 seconds the vehicle lurches forward heavily and spins both rear tires.
I replaced the front hub assemblies in December 2011 with parts purchased from autopartsmidwest.com. On December 18, 2012, the left hub assembly failed and the wheel came off. The outer portion of the ball bearing race came off the splined hub. I was going very slowly AT the time the failure occurred and there was no injury or damage other than to the hub assembly, caliper bracket and some other brake parts. The total cost of repair parts not including labor is about $500. I have no knowledge of the manufacturer of the hub assembly. It should be reasonable to expect a critical part like a hub assembly to last more than about 6000 miles.
Transmission and drivetrain complaints across Explorer years
Questions about transmission and drivetrain problems
How common are transmission and drivetrain problems on the 1996 Ford Explorer?
120 owners have reported transmission and drivetrain problems to NHTSA, 8% of all complaints for this model year.