Ford · Explorer

1998 Ford Explorer Speed control Problems

Special purpose vehicle · 4WD/AWD, RWD · Regular

Owners of the 1998 Ford Explorer have reported 281 speed control problems to NHTSA, 14% of all complaints about this model year.

Where owners named a specific part, the most common were accelerator pedal (87), cruise control (33), and linkages (11).

The typical report came at around 113,000 miles, and complaints were filed between February 1998 and January 2020.

These speed control complaints include 31 crashes, 49 fires, 7 injuries, and 1 death.

No other Explorer year has as many speed control complaints.

Accelerator pedals, throttle bodies and cruise control: unintended acceleration, stuck throttles and surging.

4 recalls for this model year involve the speed control. If your problem matches, a dealer repairs it free under the recall.
Complaints281
Typical mileage113k
Crashes / fires31 / 49
Injuries7

Parts named in these complaints

  • Accelerator Pedal87
  • Cruise Control33
  • Linkages11
  • Cables2

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Speed control Filed Jan 2020 182,000 miles NC

Speed control gets hot to touch. All top facing has melted off from heat. I was on highway and my steering wheel became extremely hot. My seat was repaired after recall years ago. It continues to drop low to floor.

Owner complaint 11298074 filed with NHTSA
Speed control Filed Jul 2018 MN

Gas pedal bracket welding broke while driving and gas pedal is now just dangling - checked on internet and there are a large amount of complaints about same thing - should be a recall

Owner complaint 11105330 filed with NHTSA
Speed control Filed May 2018 CO

Tl* the contact owns a 1998 Ford Explorer. While the vehicle was in operation, the accelerator pedal became detached. The contact activated the hazard lights and drove home with caution. The dealer (phil long Ford AT chapel hills, 1565 auto mall loop, colorado springs, co 80920, (719) 387-1099) was notified, but could not diagnose the cause of the failure. The dealer and manufacturer indicated that there was no recall to provide a remedy. The contact was uncertain that if the part were replaced, the failure would recur. The failure mileage was not available.

Owner complaint 11093383 filed with NHTSA

Related recalls

09V399000 Filed Oct 13, 2009 4,500,000 vehicles

Vehicle speed control

Ford is recalling model years 1995-2003 windstar, 2000-2003 excursion diesel, 1993-1997 and 1999-2003 F-250 sd through f-550 sd diesel, 1992-2003 e-150 through e-550, 1995-2002 explorer, 1997 and 2002 mercury mountaineer, 1995-1997 and 2001-2003 ranger, and 1994 f53 vehicles equipped with the texas instruments speed control deactivation switch (scds). The scds may leak internally and then overheat, smoke, or burn.

Risk and remedy
Risk
A vehicle fire could occur with or without the engine running.
Remedy
Ford will notify owners that dealers will install a fused wiring harness in line with the scds. On 1999-2003 windstar vehicles with a leaking scds, dealers will also inspect the ABS control module connector and repair as necessary. Repairs will be completed free of charge. The safety recall began on october 27, 2009. Owners may contact ford AT 1-888-222-2751.
Filed by
FORD MOTOR COMPANY (manufacturer number 09S09)
06V286000 Filed Aug 1, 2006 1,200,000 vehicles

Vehicle speed control

On certain trucks equipped with speed control, gasoline or natural gas engines, the speed control deactivation switch may overheat.

Risk and remedy
Risk
Overheating could result in smoke or burn and an underhood fire.
Remedy
Dealers will install a fused wiring harness into the speed control system free of charge. The recall began on august 7, 2006. Owners may contact ford AT 1-866-436-7332. (note: also see recalls 05v017 and 05v388)
Filed by
FORD MOTOR COMPANY (manufacturer number 05S28)
00V422000 Filed Dec 27, 2000 220,000 vehicles

Vehicle speed control

Vehicle description: sport utility vehicles equipped with 4.0l sohc engines and still retain the original throttle body (part numbers 97jf-9e926ab or 97jf-9e926-AC). Some of the original throttle bodies installed allowed a gap between the plate and bore to be built too narrow. This reduced clearance allowed the engine deposits normally present in the throttle body to contact or bridge the gap. If the engine deposits bridged the gap between the throttle plate and bore and then hardened, on the initial application of the accelerator pedal after the engine has cooled, the operator would need to apply additional force to the accelerator pedal to break the bridge.

Risk and remedy
Risk
This could result in engine surge when the accelerator pedal breaks free.
Remedy
Dealers will replace the original throttle bodies.
Filed by
FORD MOTOR COMPANY (manufacturer number 00S58)
99V062001 Filed Mar 30, 1999 898,739 vehicles

Vehicle speed control

Vehicle description: certain 1997-1999 rhd explorer equipped with 4.0l ohv/sohc engines and cruise control built from may 29, 1996 through march 4, 1999; 1998-1999 explorer/mountaineers equipped with 4.0l ohv/sohc or 5.0l engines or 1998-1999 rangers equipped with 2.5l, 3.0l ffv/efi or 4.0l engines and cruise control built from january 5, 1998 through march 4, 1999; 1998-1999 mustangs equipped with 3.8l, 4.6l 2-valve or 4-valve engines and cruise control built from march 2, 1998 through march 4, 1999; 1999 f250/f350/f450/f550 (over 8,500 lbs.) trucks equipped with 5.4l or 6.8l engines and cruise control built from march 2, 1998 through march 4, 1999; and 1999 f-53 stripped chassis equipped with 5.4l or 6.8l engines and cruise control built from march 2, 1998 through march 4, 1999. A cruise control cable CAN interfere with the speed control servo pulley and not allow the throttle to return to idle when disengaging the cruise control.

Risk and remedy
Risk
If the cruise control is used and this condition is present, a stuck throttle could result, which could potentially result in a crash.
Remedy
Dealers will replace the cruise control cables. AT the present time, the replacement cables are not available. Customers are being advised not to use the cruise control system until a replacement CAN be made.
Filed by
FORD MOTOR COMPANY (manufacturer number 99S09)

Speed control complaints across Explorer years

Questions about speed control problems

How common are speed control problems on the 1998 Ford Explorer?

281 owners have reported speed control problems to NHTSA, 14% of all complaints for this model year.

Is there a recall for speed control problems on the 1998 Ford Explorer?

Yes. 4 recalls for this model year concern the speed control: 09V399000, 06V286000, 00V422000, 99V062001.