Owners of the 1994 Ford F-150 have reported 13 seat problems to NHTSA, 2% of all complaints about this model year.
Where owners named a specific part, the most common were front assembly (4).
The typical report came at around 75,000 miles, and complaints were filed between March 1995 and August 2012.
These seat complaints include 2 fires and 1 injury.
For comparison, the 2001 F-150 has the most seat complaints of any year, with 86.
Seat frames, recliners, tracks, heated seats and head restraints.
1 recall for this model year involves the seat.
If your problem matches, a dealer repairs it free under the recall.
Complaints13
Typical mileage75k
Crashes / fires0 / 2
Injuries1
Parts named in these complaints
Front Assembly4
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SeatsFiled Aug 2012181,100 milesIN
While driving my seat recliner bolts broke from the seat frame causing the seat to recline all the way to the back seat in my extended cab. I was able to not lose control of my truck thankfully however I have it temporarily fixed with a bolt stuck through it to keep it from reclining. Upon calling Ford they told me that even though I found a recall for this issue; it however did not affect my VIN #. I believe this is a safety issue and should be addressed.
Owner complaint 10472007 filed with NHTSA
SeatsFiled May 200920,000 milesCA
Tl*the contact owns a 1994 Ford F-150. The contact stated that the parking brake would not hold the vehicle, which causes it to roll freely. Secondly, the bumper is abnormally loose and rattles. As a result, the bumper could separate from the vehicle. Thirdly, the seat back reclines suddenly. Lastly, the front driver's side air bag warning light consistently illuminates on the instrument panel. The light indicates a failure within the air bag system. The manufacturer would not assist with the repairs because the VIN was excluded from NHTSA campaign ID numbers 93v184000, 94v018000, 94v169001, and 96e010000. The vehicle has not been repaired.
The wire harness for the power lumbar feature on the seat is underneath the front seat cushion support wires. The support wires on the driver seat CAN contact and damage the insulation harness resulting in a high resistance electrical short through the support wires.
Risk and remedy
Risk
Consequence of defect: over heating of the support wires could result, and melting, smoke, or possible igntion of the surrounding materials could occur.
Remedy
Dealers will inspect the seats on the affected vehicles. If no damage is found, the driver seat wire harness will be covered with a protective convolute tubing, wrapped with electrical tape and the harness will be rerouted. If damage is found, the wire harness will be replaced.