Owners of the 1990 Ford F-250 have reported 28 brakes problems to NHTSA, 25% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (18), antilock/traction control/electronic limited slip (9), and power assist (1).
The typical report came at around 69,000 miles, and complaints were filed between January 1995 and August 2005.
These brakes complaints include 2 crashes.
For comparison, the 1999 F-250 has the most brakes complaints of any year, with 108.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 200569,000 milesUT
Dt NHTSA recall 92v026000 was issued. However, this vehicle was not included in the recall due to VIN. My brakes failed. The dealer has not looked AT the vehicle because they would charge the consumer for the repairs. Contacted Ford, they gave the run around. There was no warning before the brakes went out. The brake fluid was over heating. The brake pedal went down to the floor. Had to use emergency brake, and the brakes on the boat that I was towing. This happened on Friday August 12, 2005.
Owner complaint 10132860 filed with NHTSA
BrakesFiled Oct 2000NJ
Equipped with towing package axle seal failed, and leaked oil onto brake line ,causing failure of brakes. 2. Light switch shorted out, burning all wires, and causing fire hazard.
Owner complaint 874047 filed with NHTSA
BrakesFiled Sep 1999MS
Vehicle repaired twice under recall #92v026000. The left front wheel would lock up when brakes applied / pull into another lane when this happens. Took vehicle back to dealer who refused repairs due vehicle being out of warranty.
A revised brake lining noise insulator resulted in a decrease in the thermal insulation between the brake lining and the front brake caliper piston. This caused greater heat transfer to the caliper pistons with the potential to overheat the brake fluid and diminish brake effectiveness during severe braking conditions.
Risk and remedy
Risk
Increased stopping distances and inablility to holdvehicles on a steep grade results in increased risk of accident in the event ofa sudden stop or when constant braking is needed to maneuver through areas withsteep grades.
Remedy
Add snap-in insulators that attach to each of the front brake caliper pistons. In addition, vehicles with 7.5 l engines will have insulation added to the engine compartment brake lines.