Owners of the 1995 Ford F-250 have reported 6 seat problems to NHTSA, 3% of all complaints about this model year.
Where owners named a specific part, the most common were front assembly (2).
The typical report came at around 226,000 miles, and complaints were filed between January 1995 and April 2016.
No other F-250 year has as many seat complaints.
Seat frames, recliners, tracks, heated seats and head restraints.
1 recall for this model year involves the seat.
If your problem matches, a dealer repairs it free under the recall.
Complaints6
Typical mileage226k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Front Assembly2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SeatsFiled Aug 2001OK
While starting vehicle , and soon after shifting into second while clutch was still depressed, driver's back seat released, causing consumer to lay down. As a result, consumer's foot released clutch, and vehicle started to travel forward while consumer was still laying down. *ak a faulty bolt caused failure and caused lumbar brace to break welds, consumer was told he would be reimbursed, however was later refused due to mileage.
Owner complaint 894538 filed with NHTSA
SeatsFiled Jul 2001NC
While driving to work this morning the lumber support brace internal to driver's side fold down portion of seat gave way. No apparent cause. I AM not a large man (5"10" 182 lbs.) and have been the principal driver for life of truck. Have sent Ford email, reference number kmm1050021cokm, case ID 352179. Very concerned about what support would have been provided in the event of a rear end crash.
The wire harness for the power lumbar feature on the seat is underneath the front seat cushion support wires. The support wires on the driver seat CAN contact and damage the insulation harness resulting in a high resistance electrical short through the support wires.
Risk and remedy
Risk
Consequence of defect: over heating of the support wires could result, and melting, smoke, or possible igntion of the surrounding materials could occur.
Remedy
Dealers will inspect the seats on the affected vehicles. If no damage is found, the driver seat wire harness will be covered with a protective convolute tubing, wrapped with electrical tape and the harness will be rerouted. If damage is found, the wire harness will be replaced.