There are 5 safety recalls on file for the 1991 Ford F-350,
filed between March 1992 and April 1996.
Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1991 F-350 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1996 (1)
96V071000
Filed Apr 25, 1996 7,900,000 vehicles
The ignition switch could experience an internal short circuit.
Risk and remedy
- Risk
- This condition could cause overheating, smoke, and possibly fire in the steering column area of the vehicle.
- Remedy
- Dealers will replace the ignition switch.
- Filed by
- FORD MOTOR COMPANY
1994 (1)
The steel fuel return tubes that connect the frame fuel return lines with the engine fuel rail CAN contact the pinch weld flange connecting the dash panel to the floor pan. Continued contact leads to abrasion of the steel fuel return tube and eventually results in a fuel leak.
Risk and remedy
- Risk
- Abrasion of the steel tube wall that eventually causes a fuel leak may result in a fire, if a source of ignition is present.
- Remedy
- Ford dealers will replace the fuel return tubes with flexible stainless steel braided/teflon tubes. Dealers will also inspect the fuel supply tubes.
- Filed by
- FORD MOTOR COMPANY
1993 (2)
93V125000
Filed Aug 2, 1993 1,131,000 vehicles
A malfunctioning check valve within the fuel pump assembly causes a portion of the unused fuel from one tank to be returned to the second tank. When this occurs, the capacity of the second tank CAN be exceeded, causing fuel spillage.
Risk and remedy
- Risk
- Spilled fuel CAN result in a fire when exposed to asource of ignition.
- Remedy
- Replacement of the fuel pressure regulator and installation of redundant check valves.
- Filed by
- FORD MOTOR COMPANY
Keys attached to the key ring of an ignition key while it is in the vehicle ignition CAN become lodged in the steering lock receiver as the steering wheel is being turned.
Risk and remedy
- Risk
- The lodged keys CAN cause loss of steering control, whichcan result in an accident when the vehicle is being used on the highway.
- Remedy
- A shield will be positioned between the steering wheel and the ignition switch and held in place by the steering lock band.
- Filed by
- FAIRMONT TAMPER
1992 (1)
A revised brake lining noise insulator resulted in a decrease in the thermal insulation between the brake lining and the front brake caliper piston. This caused greater heat transfer to the caliper pistons with the potential to overheat the brake fluid and diminish brake effectiveness during severe braking conditions.
Risk and remedy
- Risk
- Increased stopping distances and inablility to holdvehicles on a steep grade results in increased risk of accident in the event ofa sudden stop or when constant braking is needed to maneuver through areas withsteep grades.
- Remedy
- Add snap-in insulators that attach to each of the front brake caliper pistons. In addition, vehicles with 7.5 l engines will have insulation added to the engine compartment brake lines.
- Filed by
- FORD MOTOR COMPANY
Recall questions
How many recalls does the 1991 Ford F-350 have?
NHTSA lists 5 recalls for the 1991 Ford F-350.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.