There are 4 safety recalls on file for the 1995 Ford F800,
filed between November 1994 and August 1995.
Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1995 F800 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1995 (2)
The hand throttle cable CAN wear the brass swivel block on the governor lever through which it passes.
Risk and remedy
- Risk
- This wear CAN result in the governor jamming in thedamaged swivel and could prevent the governor lever from returning to the idle position.
- Remedy
- Dealers will install a revised governor lever with a stainless steel swivel. Also letters will be sent to vehicle owners that have the same vehicles but do not have a ford installed hand throttle advising them that they may require service if they have had an after market hand throttle installed.
- Filed by
- FORD MOTOR COMPANY
A connector in the wiring where the tilt hood mounted lamps attach to the vehicle wiring harness was built without sealing plugs. Moisture, road salt or other contaminants CAN enter the connection resulting in crossed circuits, shorts or corrosion of the wiring of the connector.
Risk and remedy
- Risk
- The headlamps or other front-end lighting systems CAN malfunction as a result of this condition increasing the potential for a vehicle accident.
- Remedy
- Dealers will inspect the connector and install sealing plugs in the open cavities. If the inspection reveals corrosion, a new connector will be installed.
- Filed by
- FORD MOTOR COMPANY
1994 (2)
The drag link installed CAN contact the front axle i-beam under certain extreme conditions. This drag link was not intended to be installed on "low profile" vehicles.
Risk and remedy
- Risk
- This CAN result in loss of steering control.
- Remedy
- Dealers will install the correct drag link on the vehicles.
- Filed by
- FORD MOTOR COMPANY
The vehicles were manufactured without separate ABS indicator lamps. This does not comply with the requirements of fmvss no. 105, "hydraulic brake systems."
Risk and remedy
- Risk
- Consequence of non-compliance: the brake system could fail and the driver would have no warning.
- Remedy
- Dealers will install ABS indicator lamp and circuitry.
- Filed by
- FORD MOTOR COMPANY
Recall questions
How many recalls does the 1995 Ford F800 have?
NHTSA lists 4 recalls for the 1995 Ford F800.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.