Owners of the 2013 Ford Fusion have reported 30 lighting problems to NHTSA, 2% of all complaints about this model year.
Where owners named a specific part, the most common were turn signal (1) and headlights (1).
The typical report came at around 37,000 miles, and complaints were filed between February 2013 and December 2025.
These lighting complaints include 1 fire and 1 injury.
No other Fusion year has as many lighting complaints.
Headlights, taillights, brake lights, turn signals and interior lighting, including bulbs, housings and wiring.
1 recall for this model year involves the lighting.
If your problem matches, a dealer repairs it free under the recall.
Complaints30
Typical mileage37k
Crashes / fires0 / 1
Injuries1
Parts named in these complaints
Turn Signal1
Headlights1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
LightsFiled Dec 2025FL
Turn signal prematurely cancels intermittently, in middle of turn or prior to starting turn. This is after the signal stalk switch has been locked into the continuous on position, not the momentary position. The slightest movement of the steering wheel back away from the direction of turn will induce this. Not a full 1/8 of a turn back, but a very minute amount, as little as 1 or 2 degrees of steering movement. This is a known issue by the manufacturer, as they have service bulletin instructions for dealership technicians to reprogram the steering column signal switch, however, this repair is cost prohibitive at dealership rates.
Owner complaint 11706583 filed with NHTSA
LightsFiled Apr 2024CA
In March of 2024 I discovered that the passenger side front turn signal was not working. I assumed it was the bulb so I replaced it but the turn signal still failed to work. I took the vehicle to the Ford dealer where the vehicle was purchased new. Upon inspection, it was determined that a control module was the cause of the issue. I was informed that Ford no longer made the control module and the dealer would reach out to a vendor that sells used control modules for my vehicle. After several modules were obtained from a third party vendor, none of the modules would work for my vehicle.
Owner complaint 11582726 filed with NHTSA
LightsFiled Jul 2023111,000 milesNV
The contact owns a 2013 Ford Fusion. The contact stated that while driving at an undisclosed speed at night, the low-beam headlamps failed to adequately illuminate the roadway. The contact activated the high-beam headlights to see the roadway. The vehicle was taken to an independent mechanic and Auto Zone Auto Parts, where the headlamp bulbs were replaced several times; however, the failure recurred. The vehicle was not repaired. The manufacturer was made aware of the failure. The contact related the failure to NHTSA Campaign Number: 12V553000 (Exterior Lighting) however, the VIN was not included in the recall.
Ford is recalling certain model year 2013 Fusion vehicles, manufactured from February 3, 2012, through October 20, 2012, for failing to conform to the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment." The affected vehicles may not have had the low beam headlamp projector coating properly cured during its manufacturing process.
Risk and remedy
Risk
An improperly cured projector coating will become hazy through operation, over time, reducing the brightness of the low-beam lamp. This may decrease driver visibility and increase the risk of a vehicle crash.
Remedy
Ford will notify owners, and dealers will replace the headlamp assembly. The recall began on December 18, 2012. Owners may contact Ford Motor Company Customer Relationship Center at 1-866-436-7332.