Owners of the 1999 Ford Mustang have reported 20 seat belt problems to NHTSA, 9% of all complaints about this model year.
Where owners named a specific part, the most common were front (13) and rear/other (3).
The typical report came at around 36,000 miles, and complaints were filed between March 1999 and November 2015.
These seat belt complaints include 2 crashes and 3 injuries.
For comparison, the 2000 Mustang has the most seat belt complaints of any year, with 36.
Belts, buckles, retractors, pretensioners and anchorages.
1 recall for this model year involves the seat belt.
If your problem matches, a dealer repairs it free under the recall.
Complaints20
Typical mileage36k
Crashes / fires2 / 0
Injuries3
Parts named in these complaints
Front13
Rear/Other3
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Seat beltsFiled Nov 2015CA
My seat belts do not function well. Sometimes, they retract very slow, lose and sometimes they do not even retract. Also, sometime they get stuck. When I brake hard, they stuck and too tight....on the other hand sometimes they are very lose and doesn't stay tight to my chest, same is the case with the navigator seat belts and also the rear seat seat belts. It been happening for couple of weeks.
Owner complaint 10806365 filed with NHTSA
Seat beltsFiled Apr 2011FL
Tl*the contact owns a 1999 Ford Mustang. The contact noticed that the front driver and passenger seat belts would not retract similar to NHTSA campaign ID number: 99v250000 (seat belts:front:anchorage). The vehicle was taken to the dealer and the contact was advised to have the entire mechanism for both sides replaced. The contact did not inform the manufacturer nor was the vehicle repaired. The current mileages were 92,658 and the failure mileages were unknown.
Vehicle description: passenger vehicles. The seat belt retractor may have a pin shaft in the switchable elr/alr mechanism that is incorrectly formed. In some circumstances, the switching mechanism could become nonfunctional, preventing the seat belt webbing from being extracted from the retractor. It is also possible that malfunction of the mechanism could prevent the belt from being switched into the alr mode. The elr mechanism is not affected by this condition.
Risk and remedy
Risk
If the mechanism malfunctions and does not allow the webbing to be extracted, the lap and shoulder belt could not be worn by a vehicle occupant. In the event that the mechanism does not allow the alr mode to be engaged, the operator may be unable to properly install a child seat in that seating position.
Remedy
Dealers will inspect the lap and shoulder belt assemblies. Assemblies with julian date codes of 200 through 223 are suspect and will be replaced.