Owners of the 1996 Ford Taurus have reported 182 transmission problems to NHTSA, 22% of all complaints about this model year.
Where owners named a specific part, the most common were automatic transmission (153), manual transmission (20), and axle assembly (5).
The typical report came at around 98,000 miles, and complaints were filed between March 1996 and June 2010.
These transmission complaints include 4 crashes, 1 injury, and 1 death.
For comparison, the 1995 Taurus has the most transmission complaints of any year, with 394.
Automatic and manual transmissions, CVTs, clutches, axles, driveshafts and transfer cases: harsh or delayed shifts, slipping, shuddering and rolling away in park.
3 recalls for this model year involve the transmission.
If your problem matches, a dealer repairs it free under the recall.
Complaints182
Typical mileage98k
Crashes / fires4 / 0
Injuries1
Parts named in these complaints
Automatic Transmission153
Manual Transmission20
Axle Assembly5
Driveline3
Clutch Assembly1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Transmission and drivetrainFiled Jun 2010VA
1996 Ford Taurus. Consumer states problem with the park pawl *tgw the consumer stated when she put the gear in park, the park pawl did not engage, which cause the vehicle to roll. The consumer spoke with her mechanic and he informed her a recall had been issued in 1996 for certain vehicles. The consumer went to the dealer to have the problem addressed. While the dealer did acknowledge the recall and the consumers vehicle was equipped with ax4n automatic transaxles, she was advised her vehicle was not included in the recall.
Owner complaint 10336994 filed with NHTSA
Transmission and drivetrainFiled Jan 2009120,000 milesNC
Tl*the contact owns a 1996 Ford Taurus. The contact stated that the vehicle would not start. It cranks, but the ignition does not turn over until she depresses the accelerator pedal. The vehicle would stall AT least ten to twelve times before it would start. She took the vehicle to a mechanic and was informed that the fuel injectors and brake switch interlock were the causes of the failure. The vehicle is also stuck in park and will not move. In order to start the vehicle, she has to turn the ignition off and shift into neutral. The VIN was unknown. The failure mileage was 120,000. Updated 05/05/09.
Owner complaint 10256081 filed with NHTSA
Transmission and drivetrainFiled Aug 200875,000 milesNY
The transmission partially shifts between first and second gears intermittently. This has been happening for a couple months and is increasing in occurrence.
The automatic transmission park pawl shaft may not be free to rotate as intended. If the park pawl shaft does not rotate, it would prevent the park pawl from engaging the park gear when the shift lever is in the park position.
Risk and remedy
Risk
This condition could result in the vehicle rolling as if in neutral with the shift lever in the park position.
Remedy
Dealers will inspect the park pawl shaft rotation and those shafts with restricted rotation will be replaced with a shorter shaft that will not restrict rotation.
The park pawl abutment bracket has a sharp edge which CAN cause the parking pawl to hang up and not engage the park gear. This would allow the vehicle to move even though the gear shift indicator shows that the vehicle is in park.
Risk and remedy
Risk
Unintended and unexpected vehicle movement CAN result in personal injury and property damage.
Remedy
Dealers will inspect and, if necessary, replace the park pawl abutment bracket.
The park pawl shaft was improperly positioned when the roll pin that retains it was installed during transmission assembly. If the shaft was not properly positioned, the roll pin may not have lined up with the groove in the shaft and have been crushed AT assembly. Also, a burr could have been raised on the shaft.
Risk and remedy
Risk
This could result in the park pawl occasionally not engaging when the transmission selector lever is placed in the park position. This could result in the vehicle rolling as if in neutral if the vehicle operator does not apply the parking brake.
Remedy
Dealers will inspect the park pawl shaft roll pin. If the roll pin is damaged, both the roll pin and the park pawl shaft will be replaced. In addition, owners will be reminded to fully apply the parking brake, in addition to placing the transmission in park.
Filed by
FORD MOTOR COMPANY (manufacturer number 96S39)
Transmission and drivetrain complaints across Taurus years