Owners of the 1996 Ford Windstar have reported 322 transmission problems to NHTSA, 23% of all complaints about this model year.
Where owners named a specific part, the most common were automatic transmission (180), manual transmission (10), and axle assembly (7).
The typical report came at around 72,000 miles, and complaints were filed between February 1996 and March 2015.
These transmission complaints include 6 crashes, 1 fire, and 5 injuries.
For comparison, the 1995 Windstar has the most transmission complaints of any year, with 875.
Automatic and manual transmissions, CVTs, clutches, axles, driveshafts and transfer cases: harsh or delayed shifts, slipping, shuddering and rolling away in park.
2 recalls for this model year involve the transmission.
If your problem matches, a dealer repairs it free under the recall.
Complaints322
Typical mileage72k
Crashes / fires6 / 1
Injuries5
Parts named in these complaints
Automatic Transmission180
Manual Transmission10
Axle Assembly7
Driveline5
Clutch Assembly1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Transmission and drivetrainFiled Mar 201565,000 milesMD
Tl* the contact owns a 1996 Ford Windstar. While AT a stop light, the accelerator pedal was depressed but the vehicle failed to accelerate above 20 MPH. The service brake warning indicator illuminated. The failure recurred numerous times. The vehicle was taken to an independent mechanic, where it was diagnosed that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 65,000.
Owner complaint 10694170 filed with NHTSA
Transmission and drivetrainFiled Jul 201358,958 milesGA
This is a second call for help Ford corporate will not email me back. Will not verify if PCM has been updated. The van only has under 59,000 miles on it . It should not break this bad this soon makes me tell anyone on social media and our local news media and clark howards team. I do not want to call Ford unless it is agreed the phone will be recorded for court purposes. I even asked is the would let me use the updater. I sure do not want don rich Ford in villa rica ever again. They stripped the screw. That set min clearance on throttle plate. No shifts funny and sputters and terrible noise in oil pan area. Rod s knocking.
Owner complaint 10522986 filed with NHTSA
Transmission and drivetrainFiled Jun 201358,586 milesGA
Dear Ford my mother and I have been trying to get answers from the dealer and since they gave up. Because they could not fix it right the first time. Even the second or third time. The van a 1996 Windstar with 59,000 miles on it and it started the engine started stalling, when making slow turns not touching the gas pedal loses power steering. My mom almost went into a ditch to avoid a collision with another car. With little internet searching found hundreds of vans with same problems, and appears there is not one resolved. And since this has gone on for over a month. The last visit to the Ford dealer in an attempt to fix the stalling. .
The park pawl abutment bracket has a sharp edge which CAN cause the parking pawl to hang up and not engage the park gear. This would allow the vehicle to move even though the gear shift indicator shows that the vehicle is in park.
Risk and remedy
Risk
Unintended and unexpected vehicle movement CAN result in personal injury and property damage.
Remedy
Dealers will inspect and, if necessary, replace the park pawl abutment bracket.
The park pawl shaft was improperly positioned when the roll pin that retains it was installed during transmission assembly. If the shaft was not properly positioned, the roll pin may not have lined up with the groove in the shaft and have been crushed AT assembly. Also, a burr could have been raised on the shaft.
Risk and remedy
Risk
This could result in the park pawl occasionally not engaging when the transmission selector lever is placed in the park position. This could result in the vehicle rolling as if in neutral if the vehicle operator does not apply the parking brake.
Remedy
Dealers will inspect the park pawl shaft roll pin. If the roll pin is damaged, both the roll pin and the park pawl shaft will be replaced. In addition, owners will be reminded to fully apply the parking brake, in addition to placing the transmission in park.
Filed by
FORD MOTOR COMPANY (manufacturer number 96S39)
Transmission and drivetrain complaints across Windstar years