Owners of the 1993 Geo Metro have reported 8 lock and latch problems to NHTSA, 16% of all complaints about this model year.
Where owners named a specific part, the most common were hood (8).
The typical report came at around 113,000 miles, and complaints were filed between January 1996 and July 2005.
For comparison, the 1990 Metro has the most lock and latch complaints of any year, with 16.
Door, hood, liftgate and trunk latches, locks and linkages: doors that open while driving or will not open.
1 recall for this model year involves the lock and latch.
If your problem matches, a dealer repairs it free under the recall.
Complaints8
Typical mileage113k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Hood8
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Locks and latchesFiled Jul 2005113,042 milesCA
Dt: consumer states he found a recall on the NHTSA website, #93v189001. The hood flew up and off, hitting the roof and damaged the hood. He was going approximately 40 MPH. There was no warning; it had been about a week since the hood was opened. The dealership said it was out of warranty and he would have to pay for it himself and the VIN was not part of the recall. There is a case file number,1-348-257471. There was almost a accident and there was not a police report.
Owner complaint 10128334 filed with NHTSA
Locks and latchesFiled Oct 1999CA
While driving AT 70 MPH and due to cracks within the hood latch assembly, the hood flew up, cracking the windshield. Consumer was able to keep the vehicle under control and bring the vehicle to a complete stop.
Mislocated attaching spot welds of the hood striker assembly cause cracks to start on the hood inner panel. If cracks occur, the hood striker assembly may not properly engage the hood latch when the hood is closed.
Risk and remedy
Risk
An improperly engaged hood latch may result in a hoodfly-up while the vehicle is in motion. This would obstruct the driver's viewand could cause a vehicle crash.
Remedy
GM dealers will (a) install two bolts and nuts to secure the striker assembly to the hood inner panel, and (b) ensure that the hood latch assembly fasteners are properly tightened.