There are 5 safety recalls on file for the 1996 GMC C35,
filed between December 1995 and March 1997.
Each one is repaired free by a franchised GMC dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1996 C35 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1997 (1)
Vehicle description: extended cab and 2-door utility vehicles equipped with reclining seats and the easy-entry feature. These vehicles exhibit a condition in which a pinch point exists in the recliner mechanism that CAN trap and pinch a person's hand or finger(s) when the easy-entry feature is activated.
Risk and remedy
- Risk
- This pinching CAN cut the hand or possibly sever the finger(s) without prior warning.
- Remedy
- Dealers will install a protector cover over the recliner mechanism.
- Filed by
- GENERAL MOTORS CORP.
1996 (3)
These tires have bead damage which occured during tire mounting.
Risk and remedy
- Risk
- This damage to the tire reinforcing structure in the bead "toe" area causes a bulge in the sidewall after the tire is inflated. This condition will result in a slow air loss causing the tire to go flat. However, it is possible for the damage to result in a rapid air loss causing injuries to anyone if they were handling the tire when this occurred.
- Remedy
- Dealers will demount each tire and inspect for bead damage. If bead damage is found, the tire will be replaced.
- Filed by
- GENERAL MOTORS CORP.
The four u-bolts nuts on either side of the rear axle were under-torqued.
Risk and remedy
- Risk
- Vehicle usage could cause the nuts to loosen and eventually fall off the u-bolt. This could result in sudden loss of vehicle control increasing the potential for a vehicle crash.
- Remedy
- Dealers will check the u-bolt nut torque and re-torque any loose u-bolts to specification.
- Filed by
- GENERAL MOTORS CORP.
These vehicles were assembled with the throttle cable contacting the dash mat which could bind the throttle. This does not meet with the maximum return times required by federal motor vehicle safety standard no. 124, "accelerator control systems."
Risk and remedy
- Risk
- Consequence of non-compliance: the engine speed may not return to idle increasing the potential for a vehicle accident.
- Remedy
- Dealers will inspect for adequate throttle cable to dash mat clearance, and if there is insufficient clearance, cut out a portion of the dash mat to provide proper clearance.
- Filed by
- GENERAL MOTORS CORP.
1995 (1)
Certain trucks have fuel rail assemblies with an improperly crimped end retainer clip that results in a fuel leak.
Risk and remedy
- Risk
- If fuel leakage occurs and an ignition source is present, an engine compartment fire could occur.
- Remedy
- Dealers will inspect the fuel rail assembly and replace any fuel rail assembly with a julian date code of 95318 through 95338.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1996 GMC C35 have?
NHTSA lists 5 recalls for the 1996 GMC C35.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.