There are 5 safety recalls on file for the 1994 GMC K15,
filed between September 1993 and December 1995.
Each one is repaired free by a franchised GMC dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1994 K15 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1995 (1)
95V246000
Filed Dec 21, 1995 675,661 vehicles
The seat recliner to seat frame attaching bolts on these vehicle could loosen, fatigue and fracture, allowing the seat back to suddenly recline.
Risk and remedy
- Risk
- If this were to occur to the driver's seat, this could result in a sudden loss of vehicle control increasing the risk of a vehicle accident.
- Remedy
- Dealers will remove all foam and/or fabric sandwiched between the recliner assembly and the seat frame, install washers between the seat recliner and the seat frame AT each attachment point, and install new attaching bolts torqued to a higher specification. These corrections will be made to both the driver's and passenger's seats.
- Filed by
- GENERAL MOTORS CORP.
1994 (2)
The windshields were installed with incorrect windshield opening pinch-weld-flange primer. This primer will not properly etch the painted surface of the flange, allowing the windshield to separate from the vehicle during a collision. This does not comply with the requirements of fmvss no. 212, "windshield mounting."
Risk and remedy
- Risk
- Consequence of non-compliance: the separation of the windshield from the vehicle during collision increases the risk of injury for all persons involved.
- Remedy
- Dealers will remove the windshield and reinstall it using the correct primer.
- Filed by
- GENERAL MOTORS CORP.
Trucks were assembled with the left-hand lower control arm to frame rear nut tightened below the specified torque. Low torque on this nut may allow the attachment bolt to loosed and subsequently fatigue and break. The bolt breakage CAN cause the left hand control arm to separate from the frame.
Risk and remedy
- Risk
- If this occurs, a loss of vehicle control and a crash could result.
- Remedy
- Dealers will tighten the left-hand lower control arm to frame rear nut to the proper torque specification.
- Filed by
- GENERAL MOTORS CORP.
1993 (2)
The seats have been assembled without bolts that connect the upper slave hinge to the seat back frame, or without bolts that connect the seat to the seat adjuster. In either case, the vehicles fail to conform to fnvss no. 207, "seating systems."
Risk and remedy
- Risk
- The missing bolts may cause the driver's seat to becomeloose and in a sudden stop or accident may subject the occupant to increasedrisk of injury.
- Remedy
- Dealers will inspect seats for missing bolts and install bolts if required.
- Filed by
- GENERAL MOTORS CORP.
The brake pedal push rod retainer is missing, mispositioned or not properly seated.
Risk and remedy
- Risk
- Brake pedal push rod problems CAN cause the stop lampswitch and the brake booster push rod to disconnect from the brake pedal,resulting in loss of brake operation, and a vehicle crash could occur withoutprior warning.
- Remedy
- Inspect vehicles to assure the brake pedal push rod retainer is present and fully seated in its correct position.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1994 GMC K15 have?
NHTSA lists 5 recalls for the 1994 GMC K15.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.