There are 2 safety recalls on file for the 1993 GMC K35,
filed between September 1993 and December 1995.
Each one is repaired free by a franchised GMC dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1993 K35 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
95V246000
Filed Dec 21, 1995 675,661 vehicles
The seat recliner to seat frame attaching bolts on these vehicle could loosen, fatigue and fracture, allowing the seat back to suddenly recline.
Risk and remedy
- Risk
- If this were to occur to the driver's seat, this could result in a sudden loss of vehicle control increasing the risk of a vehicle accident.
- Remedy
- Dealers will remove all foam and/or fabric sandwiched between the recliner assembly and the seat frame, install washers between the seat recliner and the seat frame AT each attachment point, and install new attaching bolts torqued to a higher specification. These corrections will be made to both the driver's and passenger's seats.
- Filed by
- GENERAL MOTORS CORP.
The rear bench seat does not meet the load requirements of fmvss 207, "seating systems," because the manual latch mechanism on the folding full bench rear seat was attached to the back frame lower cross tube with domed head steel rivets instead of the bolts specified.
Risk and remedy
- Remedy
- The rivets must be replaced with the correct bolts.
- Filed by
- GENERAL MOTORS CORP.