Owners of the 1999 GMC Sierra have reported 338 brakes problems to NHTSA, 56% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (232), foundation components (29), and antilock (26).
The typical report came at around 60,000 miles, and complaints were filed between April 1999 and August 2015.
These brakes complaints include 34 crashes and 7 injuries.
No other Sierra year has as many brakes complaints.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
3 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 2015190,000 milesWV
While pulling out of my driveway I experienced complete brake failure. Looked under truck and brake fluid was everywhere and the brake lines were severely rusted and had busted. Looked it up and this appears to be a common problem with this model truck but there has never been a recall?! This issue needs to be addressed with GM.
Owner complaint 10747596 filed with NHTSA
BrakesFiled Jan 201558,000 milesKS
I was driving and went to apply brakes for the stop sign ahead, and I had no brakes. Once I had the truck home I parked it. I determined that the brake lines had rusted through by having a piece of cardboard under the truck to locate the leaking brake fluid. I'm so lucky that I didn't have a camper on the truck and had gone on vacation to colorado, as I intended this to be my recreational vehicle for this purpose. I AM haunted by the possible scenarios and crashes that could have occurred to me and my family. Wife, son, and two daughters.
Owner complaint 10679788 filed with NHTSA
BrakesFiled Sep 201481,000 milesKY
Driving down hill, approx speed of 45 MPH, went to apply brakes when did heard pop noise and brake pedal went to the floor with no stopping. Pumped on brakes and geared down truck to slow down. Pulled over to side of road to notice that fluid was coming out of the body. Was able to get mirror and research and find the brake line had corroded with rust, and it has split.
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Risk and remedy
Risk
This CAN cause increased stopping distances during low-speed brake applications, which could result in a crash.
Remedy
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
On certain pickup trucks equipped with manual transmissions and built with either pbr parking brake systems or trw parking brake systems, the parking brake friction linings may wear to an extent where the parking brake CAN become ineffective in immobilizing a parked vehicle.
Risk and remedy
Risk
If the parking brake does not hold, unintended vehicle movement could occur, which could result in a crash.
Remedy
Dealers will install a low-force spring clip retainer for vehicles equipped with a pbr parking brake system. On vehicles equipped with the trw parking brake system, dealers will install a redesigned parking brake cable assembly. The recall began on july 29, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles have a clearance condition between the front right-hand brake pipe and the body cross sill that could decrease to the point of allowing contact during the life of the vehicle. If contact occurs and the brake pipe becomes damaged, in half of the brake system there CAN be a loss of brake fluid and pressure. The brake warning lamp will be activated when the brake fluid level reaches the indicator limit.
Risk and remedy
Risk
During braking, the pedal will be lower than normal and stopping distances will be longer. If this occurs when stopping distance is limited, a crash could occur.
Remedy
Dealers will inspect the front right-hand brake pipe for wear. If there are signs of wear, this section of the brake pipe will be replaced with a new designed brake pipe section. If there are not signs of wear on the brake pipe, the dealer will install a spacer clip to ensure sufficient clearance between the brake pipe and the body cross sill.